TSB43AA82A Datasheet | Texas Instruments

FEATURES - IEEE 1394a-2000 pliant - Single 3.3-V Supply - Internal 1.8-V Circuit to Reduce Power Consumption - Integrated 400-Mbps Two-Port Physical Layer (PHY) - Internal Voltage Regulator - IEEE 1394 Related Functions: - Automated Read Response for Config ROM Register Access - Automated Single Retry Protocol and Split Transaction Control - SBP-2 Related Functions: - Supports Four Initiators by Automated Transactions and More Can Be Supported Through Firmware. - Automated Management ORB Fetching - Automated Linked mand ORB Fetching - Automated Page Table Fetching - Automated Status Block Transmit - Ability to Support Direct Print Protocol (DPP) Mode - Data Transfers: - Auto Address Increment of Direct/Indirect Addressing on Data Transfer (Packetizer) - Automated Header Insert/Strip for DMA Data Transfers - 8-/16-Bit Asynchronous and Synchronous DMA I/F With Handshake and Burst Mode - Supports ATAPI (Ultra-DMA) Mode and SCSI Mode - 8-/16-Bit Data/Address Multiplex Microcontroller and 8-/16-Bit Separated Data/Address Bus - Three FIFO Configurations That Support High Performance for the DMA and for mand Exchanges - Asynchronous mand FIFO: 1512 Bytes - Config ROM/LOG FIFO: 504 Bytes - DMA FIFO: 4728 Bytes DESCRIPTION The TSB43AA82A is a high performance 1394 integrated PHY and link layer controller. It is pliant with the IEEE 1394-1995 and IEEE 1394a-2000 specifications and supports asynchronous transfers. TSB43AA82A has a generic 16-/8-bit host bus interface. It supports parallel or multiplexed connections to the microcontroller (MCU) at rates up to 40 MHz. The TSB43AA82A offers large data transfers with three mutually independent FIFOs: 1) the asynchronous mand FIFO with 1512 Bytes, 2) the DMA FIFO with 4728 bytes and 3) the Config ROM/LOG FIFO with 504 bytes. The features of the TSB43AA82A support the serial bus protocol 2 (SBP-2). It handles up to four initiators with the SBP-2 transaction/timer manager. This SBP-2 transaction engine supports fully automated...