Datasheet4U Logo Datasheet4U.com

74CBTLV3253-Q100 - Dual 1-of-4 multiplexer/demultiplexer

General Description

The 74CBTLV3253-Q100 provides a dual 1-of-4 high-speed multiplexer/demultiplexer with two common select inputs (S0, S1) and two output enable inputs (1OE, 2OE).

Key Features

  • Automotive product qualification in accordance with AEC-Q100 (Grade 1).
  • Specified from -40 °C to +85 °C and from -40 °C to +125 °C.
  • Supply voltage range from 2.3 V to 3.6 V.
  • High noise immunity.
  • Complies with JEDEC standard:.
  • JESD8-5 (2.3 V to 2.7 V).
  • JESD8-B/JESD36 (2.7 V to 3.6 V).
  • ESD protection:.
  • MIL-STD-883, method 3015 exceeds 2000 V.
  • HBM JESD22-A114F exceeds 2000 V.
  • MM JESD22-A115-A exceeds.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
74CBTLV3253 LOW-VOLTAGE DUAL 1-OF-4 MULTIPLEXER/DEMULTIPLEXER Renesas
74CBTLV3257 Quad 1-of-2 multiplexer/demultiplexer NXP
74CBTLV3257 LOW-VOLTAGE QUAD 2:1MUX/DEMUX BUS SWITCH Renesas
74CBTLV3244 LOW-VOLTAGE OCTAL BUS SWITCH Renesas
74CBTLV3244 LOW-VOLTAGE OCTAL BUS SWITCH IDT

Other Datasheets by Nexperia

Part Number Description
74CBTLV3253 Dual 1-of-4 multiplexer/demultiplexer
74CBTLV3253D Dual 1-of-4 multiplexer/demultiplexer
74CBTLV3257 Quad 1-of-2 multiplexer/demultiplexer
74CBTLV3257-Q100 Quad 1-of-2 multiplexer/demultiplexer
74CBTLV3244 8-bit bus switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
74CBTLV3253-Q100 Dual 1-of-4 multiplexer/demultiplexer Rev. 3 — 24 September 2020 Product data sheet 1. General description The 74CBTLV3253-Q100 provides a dual 1-of-4 high-speed multiplexer/demultiplexer with two common select inputs (S0, S1) and two output enable inputs (1OE, 2OE). The low ON resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. When pin nOE = LOW, one of the four switches is selected (low-impedance ON-state) with pins S0 and S1. When pin nOE = HIGH, all switches are in the high-impedance OFF-state, independent of pins S0 and S1. To ensure the high-impedance OFF-state during power-up or power-down, nOE should be tied to the VCC through a pull-up resistor.