onsemi LC898113
The LC898113 is device integrating digital gyro interface, gyro filter, stepping motor control circuit, and motor driver functions needed to implement an Optical Image Stabilization (OIS) system using stepping motors. These functions make it possible to build a system using a minimal software program that enables the host microcontroller to turn Optical Image Stabilization (OIS) on and off, for example. The gyro filter coefficients may be set to any values by the host microcontroller, making it possible to build filter circuits optimized for the system.| Part No. | LC898113 |
|---|---|
| Datasheet | LC898113 Download |
| Manufacturer |  onsemi |
| Description | Optical Image Stabilization (OIS) Controller & Driver |
| Buy | Stock & Price |
FEATURES
● Serial interface SPI (mode0, mode3) I2C (F/S mode) Selection with MODE0 pin● Built in Gyro filter
● Digital Gyro Support Built in Digital Gyro I/F for each manufacturer
● Stepping motor drive mode 1-2 phase W1-2 phase 2W1-2 phase 4W1-2 phase 8W1-2 phase LFLGA49 4x4 / FLGA49 Continued on next page. * I2C Bus is a trademark of Philips Corporation. ORDERING INFORMATION See detailed ordering and shipping information on page 7 of this data sheet. © Semiconductor Components Industries, LLC, 2015 April 2015 - Rev. 1 1 Publication Order Number : LC898113/D Continued from preceding page. LC898113
● Stepping motor driver integrated in an MCP Saturation driven H bridge 4ch Built in thermal protection circuit Built in low voltage malfunction prevention circuit Built in transistor for photo sensor drive Two driver power supplies (VM : for motor, VCC : for others)
● Operation Clock Clock generated from built in oscillation amplifier Clock input directly from CLKIN pin Selection with MODE...
