ISPICR1 Datasheet | rfsolutions

PIC IN CIRCUIT SERIAL PROGRAM ADAPTOR - - - - - In Circuit Programming of PIC Micros Direct Connection from Any PIC Programmer Picoflex Connector Easy programming of any Package! Connects directly to Programmer ZIF Socket Connects directly to Target Board Adaptor Plugs into Programmer ZIF Socket Plugs into Target PCB Adjacent to PIC Description The ISPIC Adaptor enables the In Circuit programming of PIC Microcontrollers. In circuit programming can be applied to any serially programmable part including One Time Programmable (OTP) and Flash devices. It consists of an adaptor which plugs into the ZIF socket of the users existing programmer (e.g. PICSTART+, MEL EPICA etc), and connecting cable which connects to the target board (adjacent to the PIC Micro to be programmed). The ISPIC adaptor is shipped with a low cost Molex Picoflex flying socket (on the end of the cable). A mating Picoflex PCB mounting plug (also supplied) is mounted on the target PCB. This provides easy connection for the programming cable. Alternatively any custom connection can be used Programming of a device using the ICSP technique is achieved by powering up the device and then holding RB6 and RB7 low while raising the MCLR/Vpp pin to +13 volts. This places the PIC in programming mode and a clock signal on RB6 is then used to clock data into, and out of RB7. Operation The user simply connects one end of the ISP to the standard PIC Programmer ZIF socket and the other end to the target board containing the target PIC. The PIC is simply programmed in the same way as programming a device mounted in the ZIF socket. Programming Device List (Correct at Jan ‘2002) PIC devices which can be programmed using this adaptor include the following; 12C508A, 12C509A, 12CE518, 12CE519, 12C671, 12C672, 12CE673, 12CE674. 14000. 16C505 16C554, 16C558, 16C6XX, 16C7XX. 16FXXX Note that 16C5x parts cannot be serially programmed. Configuration of ISPIC/ Programming Selector In order to serially program a...