·
23 Hits
include the capabilities to specify the I/O direction on a bit basis, to specify the output type (CMOS or N-channel open drain), and to specify the I/...
·
18 Hits
• Simple two-line (SCL and SDA) communication with a microcontroller. • 8-bit data conversion between serial and parallel by I2 C BUS. • Built-in powe...
·
12 Hits
18-GPIO port expander or 10 × 8 keypad matrix GPIOs configurable as GPIs, GPOs, and keypad rows or
columns I2C interface with auto-increment 1.65 V to...
·
12 Hits
l I2C-bus to 16-bit GPIO expander l Operating power supply voltage range of
2.3-V to 5.5-V l Low standby current consumption l 5 V tolerant I/O ports ...
·
12 Hits
l I2C-bus to 16-bit GPIO expander l Operating power supply voltage range of
2.3-V to 5.5-V l Low standby current consumption l 5 V tolerant I/O ports ...
·
11 Hits
• Is capable of providing high speed serial communication at 8 MHz. • Provides two modes: echo back mode and normal mode. • Is capable of reading seri...
·
11 Hits
and benefits
• I²C-bus to parallel port expander • Operating power supply voltage range of 1.65 V to 5.5 V • Low standby current consumption:
• 2.5 µA...
·
10 Hits
• DBX decoder, MPX decoder and SAP decoder on chip • Extensive switching possibilities for the AF outputs and the extra headphone output • Stereo and ...
·
10 Hits
• I2C to parallel port expander • Operating power-supply voltage range of 1.65 V to
5.5 V • Allows bidirectional voltage-level translation and
GPIO ex...
·
10 Hits
• Implements CAN V2.0B - Programmable bit rate up to 1 Mb/s - One programmable mask - Two programmable filters - Three auto-transmit buffers - Two mes...
·
10 Hits
a Low cost a Simple interface to TLCS-S4 microcomputers a Four 4-bit I/O ports a AND and OR directly to ports a Single 5V supply o High output drive ...
·
9 Hits
●● Industry-Standard 4-Wire Interface Simplifies Expansion of I/O Ports to Up to 28 I/Os Independent of Microprocessor Architecture • High-Speed, 26M...
·
9 Hits
1.65V to 3.6V operating voltage 16 General Purpose I/Os (GPIOs) 5V tolerant inputs Maximum stand-by current of 1uA at +1.8V SPI bus interfac...
·
8 Hits
• Simple two-line (SCL and SDA) communication with a microcontroller. • 8-bit data conversion between serial and parallel by I2 C BUS. • Built-in powe...
·
8 Hits
•1 Low Standby Current Consumption • I2C to Parallel Port Expander • Open-Drain Active-Low Interrupt Output • Operating Power-Supply Voltage Range of ...
This website uses cookies or similar technologies, to enhance your browsing experience and provide personalized recommendations. By continuing to use our website, you agree to our Privacy Policy