·
62 Hits
Y Y Y
Y Y
Y Y
Permits multiplexing from N lines to 1 line Performs parallel-to-serial conversion Strobe (enable) line provided for cascading (N lin...
·
55 Hits
to ensure that select input changes do not cause invalid output transients
Features
Y Advanced oxide-isolated ion-implanted Schottky TTL process
Y Sw...
·
46 Hits
Y Y Y Y
Applications
Y Y Y
Buffered inputs and outputs Typical propagation time 9 ns Typical power dissipation 150 mW Alternate Military Aerospace d...
·
25 Hits
s 25Ω switch connection between two ports s Minimal propagation delay through the switch s Low lCC s Zero bounce in flow-through mode s Control inputs...
·
17 Hits
s Supply voltage range: 3V to 15V Drive 2 LPTTL loads s Tenth power TTL compatible: s High noise immunity: s High noise margin: 1V guaranteed 0.45 VCC...
·
17 Hits
LOW. b) The Output LOW drive factor is 2.5 U.L. for Military (54) and 5 U.L. for Commercial (74)
Temperature Ranges.
SN54/74LS151
8-INPUT MULTIPLEX...
·
16 Hits
Y Y Y Y Y Y
Y
Y
TRI-STATE version of LS151 Interface directly with system bus Perform parallel-to-serial conversion Permit multiplexing from N-line...
·
16 Hits
a
7 Za
8 GND
16 1
N SUFFIX PLASTIC CASE 648-08
PIN NAMES S0 E I0, I1 Z Common Select Input Enable (Active LOW) Input Multiplexer Inputs Multiplexe...
·
15 Hits
both true (Y) and complement (W) outputs. The strobe input must be at a low logic level to enable this multiplexer. A high logic level at the strobe f...
·
15 Hits
1 9 S2
This analog multiplexer/demultiplexer controls analog voltages that may vary across the voltage supply range
(i.e., VCC to VEE ). It is a bidi...
·
14 Hits
44 V supply maximum rating VSS to VDD analog signal range Single- or dual-supply specifications Wide supply ranges (10.8 V to 16.5 V) Microprocessor c...
·
14 Hits
an enable input (nE). When nE is HIGH all outputs are forced HIGH. The enable input can be used as the data input for a 1-to-4 demultiplexer applicati...
·
14 Hits
• Select one of eight data outputs:
– Active low for '138 – Active high for '238 • l/O port or memory selector • Three enable inputs to simplify casca...
·
13 Hits
s 4Ω switch connection between two ports. s Minimal propagation delay through the switch. s Low lCC. s Zero bounce in flow-through mode. s Control inp...
This website uses cookies or similar technologies, to enhance your browsing experience and provide personalized recommendations. By continuing to use our website, you agree to our Privacy Policy