16K-BIT SERIAL EEPROM WITH MICROWIRE INTEFACE
(compatible to САТ93С86 Catalyst)
The IN93LC86 is a Electric erasable programmable ROM (EEPROM) memory data capac-
ity 4K (2048x8 or 1024x16) with 3-wire interface.
There are 3 modification of ICs
A: ICs IN93AA86AD/AN are 8 bits registers (2048х8) - ORG pin not used
B: ICs IN93AA86BD/BN are 16 bits registers (1024х16) - ORG pin not used
C: ICs IN93AA86CN/CD are configured as either registers of 8 bits (ORG pin at GND) or
16 bits (ORG pin at VCC, or not connected). Each register can be written (or read) serially
by using the DI (or DO) pin.
The ICs is purposed for reading, writing & nonvolatile data storage. ICs can be used in
TV-sets, telecom equipment & consumer electronic devices.
■ 100 year data (16K) retention for Ta=25oC;
■ Single power supply source (VСС = 1,8 V – 6,0 V);
■ Build-in voltage multiplier;
■ Serial I/O bus;
■ Autoincrement of address word;
■ Self-timed write cycle;
■ 1,000,000 Program/erase cycles;
■ Power-up internal logic setup;
■ Read cycles quantity are not limited;
■ Low power consumption;
■ Operating temperature range -40 … +85 oC.
1 D SUFFIX
CS Chip Select
SK Clock Input
DI Serial Data Input
07 NC (ORG)
Serial Data Output
+1.8 to 6.0V Power Supply
Memory Organization pin *
NC No Connection
* this pin is present only in IN93AA86CN, IN93AA86CD:
When the ORG pin is connected to VCC, the x16 organization is selected.
When it is connected to ground, the x8 pin is selected.
If the ORG pin is left unconnected, then an internal pullup device will select the x16 organization.