LPS355-CF
Key Features
- Active power factor correction IEC EN6100-3-2 compliance Remote sense Power fail and remote inhibit Single wire current sharing Built-in EMI filter Low output ripple Supervisory output 5 V and 12 V Overvoltage protection Overload protection Thermal overload protection DC power good Cover -C 130 KHz switching frequency Optional with fan cover -CF Optional end-mounted fan - CEF Output Maximum power With cover: 350 W with 30 CFM forced air, (-C) (-CF) (-CEF) 2:1 wide ratio 5 V @ 500 mA regulated, 12 V @ 150 20 ms @ 350 W load, 115 VAC nominal line at factory voltage setting Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating 5 V output: 5.7-6.7 VDC. Other models 10% to 25% above nominal output TTL logic signal goes high 50-150 msec after 5 V output. It goes low at least 4 msec before loss of regulation Requires an external contact (N.O or N.C) to inhibit outputs TTL logic goes high 50-150 msec after the output. It goes low when there is loss of regulation. Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Reverse connection protected. Adjustment range Supervisory outputs mA x2 Hold-up time Overload protection Overvoltage protection Logic Control Power failure Environmental Operating temperature: 0° to 50°C ambient derate each output at 2.5% per degree from 50° to 70°C Electromagnetic sus
