Datasheet4U Logo Datasheet4U.com

IS32BL3552 - BOOST TYPE LED DRIVER

General Description

The IS32BL3552 is a white LED driver for backlight applications based on a highly efficient boost controller operating over a wide input voltage range of 4.5V to 33V.

Key Features

  • to prevent damage during fault conditions. Protection features include an internal soft-start circuit to prevent a high inrush current during startup, open/short LED protection to automatically disable a faulty current source, over temperature protection (OTP), cycle-by-cycle current limit, under voltage lockout (UVLO), programmable OVP, VOUT short / Schottky diode open protection and Schottky Diode short-circuit protection. The IS32BL3552 is available in a thermally enhanced eTSSOP-16 package.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
IS32CS8977 MCU Lumissil
IS32CS8979 18-channel LED drivers Lumissil
IS32FL3202 SMART LED CONTROLLER Lumissil
IS32FL3207 18-CHANNEL LED DRIVER Lumissil
IS32FL3209 18-CHANNELS LED DRIVER Lumissil

Other Datasheets by ISSI (now Infineon)

Part Number Description
IS32BL3554 BOOST TYPE LED DRIVER
IS32FL3738 6 x 8 DOTS MATRIX LED DRIVER
IS32LT3117 4-CHANNEL CONSTANT CURRENT REGULATOR
IS32LT3120 LINEAR LED DRIVER
IS32LT3175N SINGLE CHANNEL LINEAR LED DRIVER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
IS32BL3552 BOOST TYPE LED DRIVER WITH 2-CHANNEL CURRENT SOURCE Preliminary Information August 2014 GENERAL DESCRIPTION The IS32BL3552 is a white LED driver for backlight applications based on a highly efficient boost controller operating over a wide input voltage range of 4.5V to 33V. The IS32BL3552 contains four regulated current sources with 1.5% (Typ.) current matching between strings for a uniform LED brightness. Each current source can be programmed via an external resistor to drive from 40mA to 360mA. A fast slew rate current source allows high frequency and narrow pulse width dimming signals to achieve a very high contrast ratio. The device operating frequency can be adjusted from 0.1MHz to 1MHz.