IPS1021(S)(R)
www.DataSheet4U.com
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters
are referenced to Ground lead. (Tambient=25°C unless otherwise specified).
Symbol Parameter
Min. Max. Units
Vds Maximum drain to source voltage
-0.3 36
V
Vds cont. Maximum continuous drain to source voltage
- 28 V
Vin Maximum input voltage
-0.3 6
V
Isd cont.
Max. diode continuous current (limited by thermal dissipation)
⎯ 4.5
A
Maximum power dissipation (internally limited by thermal protection)
Pd
Rth=5°C/W IPS1021
Rth=40°C/W IPS1021S 1” sqr. footprint
⎯ 25 W
⎯ 3.1
Rth=50°C/W IPS1021R 1” sqr. footprint
⎯ 2.5
Electrostatic discharge voltage (Human body) C=100pF, R=1500Ω
Between drain and source
⎯4
ESD
Other combinations
Electrostatic discharge voltage (Machine Model) C=200pF,R=0Ω
⎯ 3 kV
Between drain and source
⎯ 0.5
Other combinations
⎯ 0.3
Tj max.
Max. storage & operating temperature junction temperature
-40 150
°C
Tsoldering Lead soldering temperature (10 seconds)
⎯ 300 °C
Thermal Characteristics
Symbol
Parameter
Rth1
Thermal resistance junction to ambient IPS1021 TO-220 free air
Rth2
Thermal resistance junction to case IPS1021 TO-220
Rth1
Thermal resistance junction to ambient IPS1021S D²Pak std. footprint
Rth2
Thermal resistance junction to ambient IPS1021S D²Pak 1” sqr. footprint
Rth3
Thermal resistance junction to case IPS1021S D²Pak
Rth1
Thermal resistance junction to ambient IPS1021R D-Pak std. footprint
Rth2
Thermal resistance junction to ambient IPS1021R D-Pak 1” sqr. footprint
Rth3
Thermal resistance junction to case IPS1021R D-Pak
Typ.
50
2.6
60
40
2.6
70
50
2.6
Max.
⎯
⎯
⎯
⎯
⎯
⎯
⎯
⎯
Units
°C/W
Recommended Operating Conditions
These values are given for a quick design. For operation outside these conditions, please consult the application notes.
Symbol
Parameter
Min. Max. Units
VIH High level input voltage
4.5 5.5
VIL Low level input voltage
0 0.5
Ids Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=5°C/W IPS1021
⎯ 13.5
A
Rth=40°C/W IPS1021S 1” sqr. footprint
⎯ 4.8
Rth=50°C/W IPS1021R 1” sqr. footprint
⎯ 4.3
Rin
Recommended resistor in series with IN pin to generate a diagnostic
0.5 10
kΩ
Max L
Max. recommended load inductance (including line inductance) (1)
⎯ 20 µH
Max F
Max. frequency (switching losses = conduction losses)
⎯ 500 Hz
Max t rise
Max. input rising time
⎯ 1 µs
(1) Higher inductance is possible if maximum load current is limited - see figure 11
www.irf.com
2
