MAX5839 Datasheet | Maxim Integrated

Description The MAX5839 contains eight 13-bit, voltage-output digital-to-analog converters (DACs). On-chip precision output amplifiers provide the voltage outputs. The device operates from +14V/-9V supplies. Its bipolar output voltage swing ranges from +9V to -4V and is achieved with no external ponents. The MAX5839 has three pairs of differential reference inputs; two of these pairs are connected to two DACs each, and a third pair is connected to four DACs. The references are independently controlled, providing different full-scale output voltages to the respective DACs. The MAX5839 operates within the following voltage ranges: VDD = +7V to +14V, VSS = -5V to -9V, and VCC = +4.75V to +5.25V. The MAX5839 features double-buffered interface logic with a 13-bit parallel data bus. Each DAC has an input latch and a DAC latch. Data in the DAC latch sets the output voltage. The eight input latches are addressed with three address lines. Data is loaded to the input latch with a single write instruction. An asynchronous load input (LD) transfers data from the input latch to the DAC latch. The LD input controls all DACs; therefore, all DACs can be updated simultaneously by asserting the LD pin. An asynchronous CLR input sets the output of all eight DACs to the respective DUTGND input of the op amp. Note that CLR is a CMOS input, which is powered by VDD. All other logic inputs are TTL/CMOS patible. The “A” grade of the MAX5839 has a maximum INL of ±2LSBs, while the “B” grade has a maximum INL of ±4LSBs. Both grades are available in 44-pin MQFP packages. o 8 DACs in a Single Package o Buffered Voltage Outputs o Unipolar or Bipolar Voltage Swing to +9V and -4V o 22µs Output Settling Time o Drives up to 10,000p F Capacitive Load o Low Output Glitch: 30m V o Low Power Consumption: 10m A (typ) o Small Package: 44-Pin MQFP o Double-Buffered Digital Inputs o Asynchronous Load Updates All DACs Simultaneously o Asynchronous CLR Forces All DACs to DUTGND Potential Features o Full 13-Bit...