Datasheet4U Logo Datasheet4U.com

FST71100SM - 70 Amp Rectifier 20 to 100 Volts Schottky Barrier

General Description

The Fairchild Switch FST6800 provides 10-bits of highspeed CMOS TTL-compatible bus switching.

The low on resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise.

Key Features

  • s 4Ω switch connection between two ports. s Minimal propagation delay through the switch. s Low lCC. s Zero bounce in flow-through mode. s Output precharge to minimize live insertion noise. s Control inputs compatible with TTL level. Ordering Code: Order Number FST6800WM FST6800QSC FST6800MTC Package Number M24B MQA24 MTC24 Package.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
FST100100 SCHOTTKY DIODE TRANSYS
FST100100 SCHOTTKY DIODE MODULE DACO
FST100100 Silicon Power Schottky Diode GeneSiC
FST100150 Silicon Power Schottky Diode GeneSiC
FST10020 Silicon Power Schottky Diode GeneSiC

Other Datasheets by Micro Commercial Components

Part Number Description
FST7120SM 70 Amp Rectifier 20 to 100 Volts Schottky Barrier
FST7130SM 70 Amp Rectifier 20 to 100 Volts Schottky Barrier
FST7135SM 70 Amp Rectifier 20 to 100 Volts Schottky Barrier
FST7140SM 70 Amp Rectifier 20 to 100 Volts Schottky Barrier
FST7145SM 70 Amp Rectifier 20 to 100 Volts Schottky Barrier

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
FST6800 10-Bit Bus Switch with Pre-Charged Outputs June 1997 Revised December 1999 FST6800 10-Bit Bus Switch with Pre-Charged Outputs General Description The Fairchild Switch FST6800 provides 10-bits of highspeed CMOS TTL-compatible bus switching. The low on resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. The device precharges the B Port to a selectable bias voltage (BiasV) to minimize live insertion noise. The device is organized as a 10-bit switch with a bus enable (OE) signal. When OE is LOW, the switch is ON and Port A is connected to Port B. When OE is HIGH, the switch is OPEN and the B Port is precharged to BiasV through an equivalent 10-kΩ resistor.