Datasheet4U Logo Datasheet4U.com

KMA200 - Programmable angle sensor

Description

The KMA200 is an angle sensor system.

The MagnetoResistive (MR) element and the mixed signal Integrated Circuit (IC) are integrated in one package.

This angle system is already pre-programmed, offsets are compensated and therefore, ready to use.

Features

  • Magnetic field angular sensing.
  • High accuracy.
  • Operating temperature range from 40 C to +160 C.
  • Online diagnosis.
  • Bidirectional digital interface (SPI).
  • Programmable maximum angle up to 180.
  • Pre-calibrated, ready to use device.
  • One package angle sensor system.
  • Resolution better than 0.05.
  • Digital or analog output signals (user programmable).
  • Overvoltage protection at all external pins.
  • EEPROM (user programmable).
  • Programmabl.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
KMA2D0DP20X TSOP-6 PACKAGE KEC
KMA2D3P20S P-Ch Trench MOSFET KEC
KMA2D4P20S P-Ch Trench MOSFET KEC
KMA2D4P20SA P-Channel MOSFET KEC
KMA010-xxx Board to Board Interconnecttions Advanced Interconnections

Other Datasheets by NXP Semiconductors

Part Number Description
KMA210 Programmable angle sensor
KMA220 Dual channel programmable angle sensor
KMA221 Programmable angle sensor
KMA199 Programmable angle sensor
KMA310 Programmable angle sensor

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
KMA200 Programmable angle sensor Rev. 8 — 7 December 2011 Product data sheet 1. Product profile 1.1 General description The KMA200 is an angle sensor system. The MagnetoResistive (MR) element and the mixed signal Integrated Circuit (IC) are integrated in one package. This angle system is already pre-programmed, offsets are compensated and therefore, ready to use. Via the Serial Peripheral Interface (SPI) the KMA200 is user programmable. This allows user specific adjustments of the maximum angle, zero point, clamping level and a 32-bit identifier. The data is stored permanently in an Electrically Erasable Programmable Read-Only Memory (EEPROM). The device can be programmed to work either in analog or digital (SPI) output mode.
Published: |