Datasheet4U Logo Datasheet4U.com

LM810 - 3-Pin Microprocessor Reset Circuits

Description

The LM809/810 microprocessor supervisory circuits can be used to monitor the power supplies in microprocessor and digital systems.

They provide a reset to the microprocessor during power-up, power-down and brown-out conditions.

Features

  • Precise monitoring of 3V, 3.3V, and 5V supply voltages Superior upgrade to MAX809/810 Fully specified over temperature 140ms min. Power-On Reset pulse width, 240ms typical Active-low RESET Output (LM809) Active-high RESET Output (LM810) n Guaranteed RESET Output valid for VCC≥1V n Low Supply Current, 15µA typ. n Power supply transient immunity n n n n.

📥 Download Datasheet

Datasheet preview – LM810

📁 Similar Datasheet

  • LM810 - 3-Pin Microprocessor Reset Circuits (Texas Instruments)
  • LM81 - Serial Interface ACPI-Compatible Microprocessor System Hardware Monitor (Texas Instruments)
  • LM80 - Serial Interface ACPI-Compatible Microprocessor System Hardware Monitor (Texas Instruments)
  • LM8002 - 3W Audio Power Amplifier (HONGLIFA ELECTRONICS)
  • LM8002 - Audio amplifier (Crystal Electronic)
  • LM8003 - 3 SIRENS AND MACHINE GUN (Unisonic Technologies)
  • LM8012P - P-Channel Enhancement Mode Power MOSFET (Leiditech)
  • LM8031 - E/D MOS LSI (Sanyo Semiconductor)
  • LM8050I - Amplifier Transistors (ON Semiconductor)
  • LM8050J - Amplifier Transistors (ON Semiconductor)
Other Datasheets by National Semiconductor
  • LM81 - Serial Interface ACPI-Compatible Microprocessor System
  • LM80 - Serial Interface ACPI-Compatible Microprocessor System Hardware Monitor
  • LM809 - 3-Pin Microprocessor Reset Circuits
  • LM82 - Remote Diode and Local Digital Temperature Sensor
  • LM8207 - TFT 18 Gamma Buffer VCOM Driver Voltage Reference
  • LM8261 - Op Amp
  • LM8262 - Op Amp
  • LM8272 - Op Amp

Full PDF Text Transcription

Click to expand full text
LM809/LM810 3-Pin Microprocessor Reset Circuits September 1999 LM809/LM810 3-Pin Microprocessor Reset Circuits General Description The LM809/810 microprocessor supervisory circuits can be used to monitor the power supplies in microprocessor and digital systems. They provide a reset to the microprocessor during power-up, power-down and brown-out conditions. The function of the LM809/810 is to monitor the VCC supply voltage, and assert a reset signal whenever this voltage declines below the factory-programmed reset threshold. The reset signal remains asserted for 240ms after VCC rises above the threshold. The LM809 has an active-low RESET output, while the LM810 has an active-high RESET output. Six standard reset voltage options are available, suitable for monitoring 5V, 3.
Published: |