PCA9535EC Datasheet | onsemi

DATA SHEET .onsemi. I/O Expander for I2C Bus with Interrupt, Low-Power, 16-bit PCA9535E, PCA9535EC The PCA9535E and PCA9535EC devices provide 16 bits of General Purpose parallel Input / Output (GPIO) expansion through the I2C- bus / SMBus. The PCA9535E and PCA9535EC consist of two 8- bit Configuration (Input or Output selection); Input, Output and Polarity Inversion (active- HIGH or active- LOW operation) registers. At power on, all I/Os default to inputs. Each I/O may be configured as either input or output by writing to its corresponding I/O configuration bit. The data for each Input or Output is kept in its corresponding Input or Output register. The Polarity Inversion register may be used to invert the polarity if the read register. All registers can be read by the system master. The PCA9535E, identical to the PCA9655E but with the internal I/O pull- up resistors removed, has greatly reduced power consumption when the I/Os are held LOW. The PCA9535EC is identical to the PCA9535E but with high- impedance open- drain outputs at all the I/O pins. The PCA9535E and PCA9535EC provide an open- drain interrupt output which is activated when any input state differs from its corresponding input port register state. The interrupt output is used to indicate to the system master that an input state has changed. The power- on reset sets the registers to their default values and initializes the device state machine. Three hardware pins (AD0, AD1, AD2) are used to configure the I2C- bus slave address of the device. The I2C- bus slave addresses of the PCA9535E and PCA9535EC are the same as the PCA9655E. This allows up to 64 of these devices in any bination to share the same I2C- bus/SMBus. SOIC- 24 DW SUFFIX CASE 751E MARKING DIAGRAMS PCA9535E(C) AWLYYWWG TSSOP- 24 DT SUFFIX CASE 948H PCA95 35E(C)G ALYW WQFN24 MT SUFFIX CASE 485BG PCA 9535E(C) ALYWG G XXXX = Specific Device Code = Assembly Location WL, L = Wafer Lot YY, Y = Year WW, W = Work Week G or G = Pb- Free...