STK672-440B-E - 2-phase Stepper Motor Driver

ON Semiconductor

Datasheet Details

Built-in motor terminal open detection function (output current OFF).
Built-in overcurrent detection function (output current OFF).
Built-in overheat detection function (output current OFF).
FAULT1 signal (active low) is output when any of motor terminal open, overcurrent, or overheat is detected. The FAULT2 signal is used to output the result of activation of protection circuit detection at 3 levels.
Built-in power on reset function.
A.

📁 STK672-440B-E Similar Datasheet

STK672-440A-E - 2-phase Stepping Motor Driver (Sanyo Semicon Device)
STK672-442A-E - 2-phase Stepping Motor Driver (Sanyo Semicon Device)
STK672-430A-E - 2-phase Stepping Motor Driver (Sanyo Semicon Device)
STK672-432A-E - 2-phase Stepping Motor Driver (Sanyo Semicon Device)
STK672-010 - Thick-Film Hybrid IC (Sanyo Semicon Device)
STK672-020 - Unipolar Fixed-Current Chopper (Sanyo Semicon Device)
STK672-040 - Microstep Operation-Supported 4-Phase Stepping Motor Driver (Io= 1.5A) (Sanyo Semicon Device)
STK672-050 - Thick-Film Hybrid IC (Sanyo Semicon Device)

Other Datasheets by ON Semiconductor

Published: Feb 2, 2016 |