900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Omron

V600-HAM81 Datasheet Preview

V600-HAM81 Datasheet

Intelligent Flag I/II

No Preview Available !

Intelligent Flag I/II
V600-HA
Innovative RFID Electronic Flags to
Replace Mechanical Flag and Kanban
Systems
• Doesn't need a program and can be used like a sensor.
• Advanced line construction at minimal cost.
• Saves space.
• Precise installation not required (Transmission distance:
www.DataSh1e0et04Um.cmommax.).
• A verification function provided on multi-functional type.
• Addition of 16-bit models to the series responds to applica-
tions from Kanban to quality control.
• Equipped with a wiring reduction mode and communications
parity check function (16-bit models).
• Both NPN and PNP output available.
• FCC certified.
Ordering Information/Specifications
Amplifier
Type
Read-only (8-bit)
Multi-functional (8-bit)
Read-only (16-bit)
Item
Model V600-HAR91
V600-HAR81
V600-HAM91
V600-HAM81
V600-HAR92
Power supply
24 VDC ±10%, ripple (p-p): 10%
Current consumption 130 mA max.
Input
Transistor output or contact output
Short-circuit current: 3 mA (typical) (IN terminal and 0-V short-circuit)
OFF voltage:
15 to 30 VDC
ON voltage:
0 to 5 VDC
Input impedance: 8.2 k
Applied voltage: 30 VDC max.
Transistor output
OFF voltage:
15 to 30 VDC
Input impedance:
8.2 k
Short-circuit current:
3 mA (typical) (for 0-V short-circuit of
INHIBIT/TRG)
ON voltage:
0 to 5 VDC
Applied voltage:
30 VDC max.
Output
NPN open collector
output, 20 mA max. at
30 VDC, residual volt-
age: 2 V max.
PNP open collector
output, 20 mA max.
at 30 VDC, residual
voltage: 2 V max.
NPN open collector PNP open collector out- NPN open collector output, 20 mA
output, 20 mA max. at put, 20 mA max. at 30 max. at 30 VDC, residual voltage: 2 V
30 VDC, residual volt- VDC, residual voltage: 2 V max.
age: 2 V max.
max.
Diagnostic functions Checks for CPU errors and transmission errors
Insulation resistance 50 Mmax. (at 500 VDC) between cable terminals and case
Dielectric strength 500 VAC, 50/60 Hz for 1 min between cable terminals and case (leakage current: 1 mA max.)
2 Intelligent Flag I/II V600-HA




Omron

V600-HAM81 Datasheet Preview

V600-HAM81 Datasheet

Intelligent Flag I/II

No Preview Available !

Type
Read-only (8-bit)
Multi-functional (8-bit)
Read-only (16-bit)
Item
Model V600-HAR91
V600-HAR81
V600-HAM91
V600-HAM81
V600-HAR92
Vibration resistance Destruction: 10 to 150 Hz, 0.3-mm double amplitude, with 4 sweeps of 8 min each in Destruction: 10 to 150 Hz, 1.5-mm
3 directions
double amplitude, with 4 sweeps
of 8 min each in 3 directions
Shock resistance Destruction: 294 m/s2, 3 times each in 6 directions
Ambient temperature 10 to 55°C (with no icing)
Ambient humidity 35% to 85% (with no condensation)
Storage temperature 25 to 65°C
Degree of protection IEC60529: IP40
Ground
Ground to 100 or less.
Material
ABS resin (case)
Cable length
Standard, 0.5 m with a dedicated connector (See note.)
Weight
Approx. 170 g
Approx. 180 g
Note: The connector is not waterproof. If there is a possibility that the connector may be exposed to water, keep it inside the control box. Be sure
www.DataSheet4U.comto use the connector together with the separately sold interface cable.
Functions
V600-HAR91/-HAR81 (Read-only type)
Reads the 8-bit data (1 byte) of the set address and outputs to the 8
data output lines.
V600-HAM91/-HAM81 (Multi-functional type)
The amplifier has the following three basic functions.
Read
Reads the 8-bit (1 byte) data of the set address and outputs to the 8
data output lines.
Interface Cable
Amplifier
V600-HAR91/81
(Connector: 20 pin)
V600-HAM91/81
V600-HAR92
(Connector: 26 pin)
Cable length
2m
5m
10 m
2m
5m
10 m
Interface Cable
V600-A60R
V600-A61R
V600-A62R
V600-A60M
V600-A61M
V600-A62M
Note: The interface cable connector is not waterproof. If there is a
possibility that the connector may be exposed to water, keep it
inside the control box. The maximum cable length is 10 m.
Write
Writes on the set address the 8-bit (1 byte) data designated via the 8
data input lines.
Verify
Reads the 8-bit data (1 byte) of the set address, compares with the 8-
bit (1 byte) data input via the 8 verification data input lines, and out-
puts the verification result.
V600-HAR92 (Read-only type)
Reads the 16-bit data (2 bytes) of the set address and outputs to the
16 data output lines.
Intelligent Flag I/II V600-HA
3


Part Number V600-HAM81
Description Intelligent Flag I/II
Maker Omron
Total Page 15 Pages
PDF Download

V600-HAM81 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 V600-HAM81 Intelligent Flag I/II
Omron
2 V600-HAM81 Intelligent Flag I/II
Omron
3 V600-HAM81 Intelligent Flag I
Omron





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy