SMT Power Inductors
High Current Composite Inductor - PA5006.XXXNLT and PM2206.XXXNLT
IATF 16949
POWER PRODUCTS
Height: 2.05mm Max
Footprint: 8.05mm x 7.8mm Max
Current Rating: up to 35Apk
Inductance Range: 0.27uH to 1.0uH
High current, low DCR, and high efficiency
High reliability
Minimized acoustic noise and minimized leakage flux noise
Available in Commercial (PA5006) and Automotive
(PM2206) grades
Electrical Specifications @ 25°C, Operating Temperature Range -55°C to +155°C
Part Number
Commerical Automotive6
Inductance
100KHz, 0.1V
uH±20%
Rated3
Current
A
DC Resistance
TYP. MAX.
mΩ mΩ
Saturation2
Current
(25°C)
A
PA5006.271NLT PM2206.271NLT
0.27
21
2.9
3.5
35
PA5006.311NLT PM2206.311NLT
0.31
20
4.0
4.8
34
PA5006.331NLT PM2206.331NLT
0.33
19
4.0
4.8
34
PA5006.471NLT PM2206.471NLT
0.47
17
5.1
6.2
28
PA5006.681NLT PM2206.681NLT
0.68
13
7.9 9.2
25
PA5006.102NLT PM2206.102NLT
1.00
11
9.8 10.8 23
Mechanical
D
mm±0.3
6.6
6.2
6.2
6.2
6.2
6.2
K Factor
for
Core Loss
141.7
141.7
141.7
103.9
82.1
67.8
Notes:
1. Actual temperature of the component during system operation (ambient plus
4. The part temperature (ambient+temp rise) should not exceed 155�C under worst
temperature rise) must be within the standard operating range.
case operating conditions. Circuit design, PCB trace size and thickness, airflow and
2. The saturation current is the current at which the initial inductance drops approxi-
other cooling provisions all affect the part temperature. Part temperature should be
mately 30% at the stated ambient temperature. This current is determined by placing
verified in the end application.
the compnent in the specified ambient environment and applying a short duration 5. The PM2206.XXXNLT part numbers are AEC-Q200 and IATF16949 certified. The
pulse current (to eliminate self-heating effect) to the component.
mechanical dimensions are 100% tested in production but do not necessarily meet a
3. The rated current is the DC current required to raise the component temperature by
product capability index (Cpk) >1.33 and therefore may not strictly conform to PPAP.
approximately 40�C. Take note that the components’ performanc varies depending 6. Special Characteristics
on the system condition. It is suggested that the component be tested at the system
level, to verify the temperature rise of the component during system operation.
1 Power.PulseElectronics.com
P810.D (04/20)