Datasheet4U Logo Datasheet4U.com

HIP1013 - Low Cost Dual Power Distribution Controller

General Description

PIN NO.

Connect to source of associated external N-Channel MOSFET switch to sense output voltage.

Key Features

  • HOT SWAP Dual Power Distribution Control for +5V and +12V or +5V and +3.3V.
  • Provides Fault Isolation.
  • Charge Pump Allows the Use of N-Channel MOSFETs.
  • Redundant Power On Controls.
  • Power Good and Over Current Latch Indicators.
  • Adjustable Turn-On Ramp.
  • Protection During Turn-On.
  • Pb-free Available.

📥 Download Datasheet

Datasheet Details

Part number HIP1013
Manufacturer Renesas
File Size 455.61 KB
Description Low Cost Dual Power Distribution Controller
Datasheet download datasheet HIP1013 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HIP1030 1A High Side Driver with Overload Protection Intersil Corporation
HIP1031 Half Amp High Side Driver with Overload Protection Intersil Corporation
HIP1090 Protected High Side Power Switch with Transient Suppression Intersil Corporation
HIP0063 Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control Intersil Corporation
HIP2106 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver Intersil Corporation

Other Datasheets by Renesas

Part Number Description
HIP1011 PCI Hot Plug Controller
HIP1011A PCI Hot Plug Controller
HIP1011B PCI Hot Plug Controller
HIP1011D Dual Slot PCI Hot Plug Controller
HIP1011E Dual Slot PCI Hot Plug Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
HIP1013 NOT RECOMMENDED FOR NEW DESIGNS NO RECOMMENDED REPLACEMENT c1o-8n8t8a-cItNoTuErRTSeIcLhonricwawl Swu.ipnpteorrstiCl.ceonmte/rtsact Low Cost Dual Power Distribution Controller DATASHEET FN4516 Rev 3.00 August 2004 The HIP1013 is a low cost HOT SWAP dual supply power distribution controller. Two external N-Channel MOSFETs are driven to distribute power while providing load fault isolation. At turn-on, the gate of each external N-Channel MOSFET is charged with a 10A current source. Capacitors on each gate (see the Typical Application Diagram), create a programmable ramp (soft turn-on) to control inrush currents. A built in charge pump supplies the gate drive for the 12V supply N-Channel MOSFET switch. Over current protection is facilitated by two external current sense resistors.