HIP4083 Datasheet PDF (Three Phase High Side Driver)

HIP4083 - Three Phase High Side Driver

Description

Gate driver supplies.

One external bootstrap diode and one capacitor are required for each.

Features

Independently Drives Three High Side N-Channel MOSFETs in Three Phase Bridge Configuration.
Bootstrap Supply Max Voltage to 95VDC.
Bias Supply Operation from 7V to 15V.
Drives 1000pF Load with Typical Rise Times of 35ns and Fall Times of 30ns.
CMOS/TTL Compatible Inputs.
Programmable Undervoltage Protection.
Pb-free Available.

Datasheet Details

Part number	HIP4083
Manufacturer	Renesas Electronics
File Size	548.18 KB
Description	Three Phase High Side Driver
Datasheet	HIP4083 Datasheet
Additional preview pages of the HIP4083 datasheet.

📁 Similar Datasheet

HIP4081 - 80V/2.5A Peak/ High Frequency Full Bridge FET Driver (Intersil Corporation)

HIP4011 - Three Phase Brushless DC Motor Controller (Intersil Corporation)

HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control (Intersil Corporation)

HIP1030 - 1A High Side Driver with Overload Protection (Intersil Corporation)

HIP1031 - Half Amp High Side Driver with Overload Protection (Intersil Corporation)

HIP1090 - Protected High Side Power Switch with Transient Suppression (Intersil Corporation)

HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver (Intersil Corporation)

HIP2500 - Half Bridge 500VDC Driver (Harris Corporation)

HIP5010 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)

HIP5011 - 7V/ 17A SynchroFET Complementary Drive Synchronous Half-Bridge (Intersil Corporation)

Full PDF Text Transcription

Click to expand full text

HIP4083 80V, 300mA Three Phase High Side Driver The HIP4083 is a three phase high side N-channel MOSFET driver, specifically targeted for PWM motor control. Two HIP4083 may be used together for 3 phase full bridge applications (see application block diagram). Alternatively, the lower gates may be controlled directly from a buffered microprocessor output. Unlike other members of the HIP408x family, the HIP4083 has no built in turn-on delay. Each output (AHO, BHO, and CHO) will turn-on 65ns after its input is switched low. Likewise, each output will turn-off 60ns after its input is switched high. Very short and very long dead times are possible when two HIP4083 are used to drive a full bridge. This dead time is controlled by the input signal timing.

Published: May 30, 2020 |