Datasheet4U Logo Datasheet4U.com

HIP9011 - Engine Knock Signal Processor

📥 Download Datasheet

Preview of HIP9011 PDF
datasheet Preview Page 2 datasheet Preview Page 3

Datasheet Details

Part number HIP9011
Manufacturer Renesas ↗
File Size 608.69 KB
Description Engine Knock Signal Processor
Datasheet download datasheet HIP9011-Renesas.pdf

HIP9011 Product details

Description

PIN NUMBER DESIGNATION DESCRIPTION 1 VDD Five volt power input.2 GND This pin is tied to ground.3 VMID This pin is connected to the internal mid-supply generator and is brought out for bypassing by a 0.022F capacitor.4 INTOUT Buffered output of the integrator.Output signal is held by an internal Sample and Hold circuit when INT/HOLD is low.5, 6 NC These pins are not internally connected.Do Not Use.7 INT/HOLD Selects whether the chip is in the Integrate Mode (Input Hig

Features

📁 HIP9011 Similar Datasheet

  • HIP9020 - Programmable Quad Buffer with Pre and Post Scaler Dividers (Intersil Corporation)
  • HIP9021 - Portable Battery Drive/Torque Controller for N-Channel MOSFETs in Motor Control Systems (Intersil Corporation)
  • HIP9022 - Dual High Speed Laser Driver (Intersil Corporation)
  • HIP0063 - Hex Low Side MOSFET Driver with Serial or Parallel Interface and Diagnostic Fault Control (Intersil Corporation)
  • HIP1030 - 1A High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1031 - Half Amp High Side Driver with Overload Protection (Intersil Corporation)
  • HIP1090 - Protected High Side Power Switch with Transient Suppression (Intersil Corporation)
  • HIP2106 - 100V/1A Peak/ Low Cost/ High Frequency Half Bridge Driver (Intersil Corporation)
Other Datasheets by Renesas
Published: |