Datasheet4U Logo Datasheet4U.com

29F200BB - M29F200BB

Description

The M29F200B is a 2 Mbit (256Kb x8 or 128Kb x16) non-volatile memory that can be read, erased and reprogrammed.

These operations can be performed using a single 5V supply.

On power-up the memory defaults to its Read mode where it can be read in the same way as a ROM or EPROM.

Features

  • ns (Read, Program, Erase etc. ). The Command Interface is disabled when the VCC Supply Voltage is less than the Lockout Voltage, VLKO. This prevents.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
29F2G08 NAND Flash Memory Micron
29F2G08AABWP MT29F2G08AABWP Micron Technology
29F2G16 NAND Flash Memory Micron
29F001TPC MX29F001TPC Macronix International
29F002 2 Megabit (256 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory Advanced Micro Devices

Other Datasheets by STMicroelectronics

Part Number Description
29F200 2 Mbit 256Kb x8 or 128Kb x16 / Boot Block Single Supply Flash Memory
29F002 2 Mbit 256Kb x8 / Boot Block Single Supply Flash Memory
29F010 1 Mbit 128Kb x8 / Uniform Block Single Supply Flash Memory
29F040 4 Mbit 512Kb x8 / Uniform Block Single Supply Flash Memory
29F160BB Boot Block Single Supply Flash Memory

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
M29F200BT M29F200BB 2 Mbit (256Kb x8 or 128Kb x16, Boot Block) Single Supply Flash Memory PRELIMINARY DATA s SINGLE 5V±10% SUPPLY VOLTAGE for PROGRAM, ERASE and READ OPERATIONS s ACCESS TIME: 45ns s PROGRAMMING TIME – 8µs per Byte/Word typical s 7 MEMORY BLOCKS – 1 Boot Block (Top or Bottom Location) – 2 Parameter and 4 Main Blocks s PROGRAM/ERASE CONTROLLER – Embedded Byte/Word Program algorithm – Embedded Multi-Block/Chip Erase algorithm – Status Register Polling and Toggle Bits – Ready/Busy Output Pin s ERASE SUSPEND and RESUME MODES – Read and Program another Block during Erase Suspend s UNLOCK BYPASS PROGRAM COMMAND – Faster Production/Batch Programming s TEMPORARY BLOCK UNPROTECTION MODE s LOW POWER CONSUMPTION – Standby and Automatic Standby s 100,000 PROGRAM/ERASE CYCLES per BLOCK
Published: |