IPS8200HQ Datasheet | STMicroelectronics

Features - Voltage operating range 10.5 V to 36 V - UVLO with hysteresis - Output current: 0.7 A or 1.0 A (IPS8200HQ or IPS8200HQ-1) per channel - Low supply current in OFF (1 m A) and ON (5.3 m A) states - 5 V and 3.3 V patible I/Os - Selectable interface on logic side SPI or parallel - 5 MHz SPI (8 or 16-bits) with output enable, daisy chain, and MCU freeze detection - 100 m A DC/DC with integrated boot diode and adjustable output voltage - 4x2 LED matrix for efficient outputs state LEDs driving - Can drive all types of loads (resistive, capacitive, and inductive) - Per-channel overload and short-circuit protection - Per-channel/independent overtemperature protection - Fast demagnetization of inductive loads (Vout clamp) - Overvoltage protection (VCC clamping) - Loss of GND protection - Power Good (supply voltage level) diagnostic - mon fault open drain output - IC warning temperature detection - VFQFPN-48L (8x6 mm) package - Designed to meet IEC61131-2, IEC61000-4-2, IEC61000-4-4, and IEC61000-4-5 Application - Programmable logic control - Industrial PC peripheral input/output - Numerical control machines Description The IPS8200HQ and IPS8200HQ -1 are monolithic 8-channel drivers, designed using STMicroelectronics™ VIPower™ technology, and intended to drive any kind of load with one side connected to the ground. Both ICs operates from 10.5 V to 36 V and feature a very low supply current, parallel or 4-wire SPI control interface, a 4x2 LED matrix, and a micropower step-down switching regulator with a peak current control loop mode. DS14313 - Rev 2 - February 2024 For further information contact your local STMicroelectronics sales office. .st. IPS8200HQ, IPS8200HQ-1 The SPI interface (enabled by SEL2 pin = H) can work up to 5 MHz in 8-bits (SEL1 = L), or 16-bits (SEL1 = H) with a parity check and extended diagnostic (DC/DC operation, case overtemperature, SPI munication Fail, and Power Good) information. In SPI mode the daisy chain is allowed, and both the OUT_EN...