Datasheet4U Logo Datasheet4U.com

SD4843P - PWM Controller

This page provides the datasheet information for the SD4843P, a member of the SD4840 PWM Controller family.

Datasheet Summary

Description

SD4840/4841/4842/4843/4844 is a current mode PWM controller with low standby power and low start current for power switch.

In standby mode, the circuit enters burst mode to reduce the standby power dissipation.

The switch frequency is 67KHz with ±2.5 KHz jitter frequency for low EMI.

Features

  • Lower start-up current (Typ.6μA).
  • Frequency jitter for low EMI.
  • Overcurrent protection.
  • Overvoltage protection.
  • Undervoltage lockout.
  • Built-in temperature protection.
  • Built-in high voltage MOSFET www. DataShee.
  • t4AUu. ctomrestart mode.
  • Built-in soft start.
  • Burst mode operation.
  • Cycle by cycle current limit.

📥 Download Datasheet

Datasheet preview – SD4843P

Datasheet Details

Part number SD4843P
Manufacturer Silan Microelectronics
File Size 787.06 KB
Description PWM Controller
Datasheet download datasheet SD4843P Datasheet
Additional preview pages of the SD4843P datasheet.

📁 Similar Datasheet

  • SD484-52-05-301 - Photodiode Arrays (ETC)
  • SD484XP67K65 - CURRENT MODE PWM CONTROLLER (SL)
  • SD4863 - Dual-Tone Bridge Audio Power Amplifier Chip (Zhenda)
  • SD48C - BIDIRECTIONAL TVS DIODE (Leiditech)
  • SD48D40-06 - DC Control Solid-State Relay (Teledyne)
  • SD48D50A - DC Control Solid-State Relay (Teledyne)
  • SD48D50A2 - DC Control Solid-State Relay (Teledyne)
  • SD400 - (SD400 / SD402) High-Speed Analog N-Channel/Enhancement-Mode DMOS FETS (Calogic)
  • SD4000C - STANDARD RECOVERY DIODES Hockey Puk Version (International Rectifier)
  • SD4001 - 4BIT MICRO CONTROLLER (AUK)
Other Datasheets by Silan Microelectronics

Full PDF Text Transcription

Click to expand full text
SD4840/4841/4842/4843/4844 CURRENT MODE PWM CONTROLLER WITH BUILT-IN HIGH VOLTAGE MOSFET DESCRIPTION SD4840/4841/4842/4843/4844 is a current mode PWM controller with low standby power and low start current for power switch. In standby mode, the circuit enters burst mode to reduce the standby power dissipation. The switch frequency is 67KHz with ±2.5 KHz jitter frequency for low EMI. The stress on transformer during power on is reduced by the builtin 15ms soft start circuit to avoid the saturation of transformer. SD4840/4841/4842/4843/4844 includes under voltage lock-out, over voltage protection, leading edge blanking, over current protection and the temperature protection. The circuit will restart automatically until the system is normal after the protection is active.
Published: |