Datasheet4U Logo Datasheet4U.com

74LVC16240A-Q100 - 16-bit buffer/line driver

Description

The 74LVC16240A-Q100 is a 16-bit inverting buffer/line driver with 3-state outputs.

The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer.

Features

  • Automotive product qualification in accordance with AEC-Q100 (Grade 1).
  • Specified from -40 °C to +85 °C and from -40 °C to +125 °C.
  • 5 V tolerant inputs/outputs for interfacing with 5 V logic.
  • Wide supply voltage range from 1.2 V to 3.6 V.
  • CMOS low power consumption.

📥 Download Datasheet

📁 Similar Datasheet

  • 74LVC16240A - 16-bit buffer/line driver (Philips)
  • 74LVC16244A - 16-bit buffer/line driver (NXP Semiconductors)
  • 74LVC162245A - 16-bit transceiver (Philips)
  • 74LVC162373A - 16-bit D-type transparent latch (Philips)
  • 74LVC162374A - 16-bit edge triggered D-type flip-flop (Philips)
  • 74LVC161 - Presettable synchronous 4-bit binary counter (Philips)
  • 74LVC161284 - 19-BIT BUS INTERFACE (Texas Instruments)
  • 74LVC161284 - LOW VOLTAGE HIGH SPEED IEEE1284 TRANSCEIVER (ST Microelectronics)
  • 74LVC163 - Presettable synchronous 4-bit binary counter (Philips)
  • 74LVC16374A - 16-bit edge triggered D-type flip-flop (Philips)
Other Datasheets by nexperia

Full PDF Text Transcription

Click to expand full text
74LVC16240A-Q100 16-bit buffer/line driver with 5 V tolerant inputs/outputs; inverting; 3-state Rev. 2 — 25 April 2019 Product data sheet 1. General description The 74LVC16240A-Q100 is a 16-bit inverting buffer/line driver with 3-state outputs. The device can be used as four 4-bit buffers, two 8-bit buffers or one 16-bit buffer. The device features four output enables (1OE, 2OE, 3OE and 4OE), each controlling four of the 3-state outputs. A HIGH on nOE causes the outputs to assume a high-impedance OFF-state. Inputs can be driven from either 3.3 V or 5 V devices. When disabled, up to 5.5 V can be applied to the outputs. These features allow the use of these devices in mixed 3.3 V and 5 V applications. This device is fully specified for partial power-down applications using IOFF.
Published: |