TPT485N Datasheet | 3PEAK

Features ± 18K ESD Protection, Bus-Polarity Correcting RS-485 Transceiver Description - Exceeds Requirements of EIA-485 Standard - Bus-Polarity Correction within 100 ms meet SGCC spec - Data Rate: 300 bps to 500 kbps - Works with Two Configurations: - Failsafe Resistors Only - Failsafe and Differential Termination Resistors - Up to 256 Nodes on a Bus (1/8 unit load) - Wide Supply Voltage 3V to 5.5V - SOIC-8 Package for Backward patibility - Bus-Pin Protection: - ±18 k V HBM protection - ±12 k V IEC61000-4-2 Contact Discharge - ±15 k V IEC61000-4-2 Air Discharge The TPT485N is a low-power RS-485 transceiver with automatic bus-polarity correction and transient protection. Upon hot plug-in, the device detects and corrects the bus polarity within the first 100 ms of bus idling. On-chip transient protection protects the device against IEC61000 ESD and EFT transients. This device has robust drivers and receivers for demanding industrial applications. The bus pins are robust to electrostatic discharge (ESD) events, with high levels of protection to Human-Body Model (HBM), Air-Gap Discharge, and Contact Discharge specifications. The device bines a differential driver and a differential receiver, which operate together from a single 5-V power supply. The driver differential outputs and the receiver differential inputs are connected internally to form a bus port suitable for half-duplex (two-wire bus) munication. The device features a wide mon-mode voltage range making the device suitable for multi-point applications over long cable runs. The TPT485N is available in SOP8 package, and is characterized from - 40°C to 125°C. Applications - E-Metering Networks - HVAC Systems - DMX512-Networks 3PEAK and the 3PEAK logo are registered trademarks of 3PEAK INCORPORATED. All other trademarks are the property of their respective owners. Function Block Diagram Rx D DIR Tx D Automatic Bus-polarity Correction With/ Without Pull-up and Pull-down Resistor Vcc...