Datasheet4U Logo Datasheet4U.com

A29800A - Boot Sector Flash Memory

General Description

on programming data to the device using both standard and Unlock Bypass command sequence.

2.

Key Features

  • Single power supply operation - Full voltage range: 4.5 to 5.5 volt for read and write operations.
  • Access time: - 55ns (max. ).
  • Current: - 20 mA typical active read current - 30 mA typical program/erase current - 6μA typical CMOS standby.
  • Flexible sector architecture - 16 Kbyte/ 8 KbyteX2/ 32 Kbyte/ 64 KbyteX15 sectors - 8 Kword/ 4 KwordX2/ 16 Kword/ 32 KwordX15 sectors - Any combination of sectors can be erased - Supports full chip erase - Sector protection:.

📥 Download Datasheet

Datasheet Details

Part number A29800A
Manufacturer AMIC
File Size 479.29 KB
Description Boot Sector Flash Memory
Datasheet download datasheet A29800A Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
A29800 Boot Sector Flash Memory AMIC Technology
A2982 8-CHANNEL SOURCE DRIVERS Allegro MicroSystems
A2987 Eight-channel Source Driver With Over-current Protection Allegro Micro Systems
A29-1 Cascadable Amplifier Tyco Electronics
A29001 Boot Sector Flash Memory AMIC Technology

Other Datasheets by AMIC

Part Number Description
A29800B Boot Sector Flash Memory
A29801A Boot Sector Flash Memory
A29801B Boot Sector Flash Memory
A290011A Boot Sector Flash Memory
A290011B Boot Sector Flash Memory

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
A29800A Series 1M X 8 Bit / 512K X 16 Bit CMOS 5.0 Volt-only, Boot Sector Flash Memory Document Title 1M X 8 Bit / 512K X 16 Bit CMOS 5.0 Volt-only, Boot Sector Flash Memory Revision History Rev. No. 0.0 1.0 1.1 1.2 1.3 History Initial issue Remove –I grade spec. Update ICC3, ICC4, VIH, Absolute Maximum Rating, Program/Erase time and Data Retention Error corrections: Modify Table 2. Top Boot Block Sector Address Table 1. Page 6 “Writing Commands/Command Sequences” section : Change The “Word/Byte Program Command Sequence” section has details on programming data to the device using both standard and Unlock Bypass command sequence.