AT76C712 Datasheet | Atmel

Features - Advanced RISC Architecture, 130 Powerful Instructions, Most Single Clock Cycle Execution - JTAG (IEEE Std. 1149.1 pliant) Interface - Boundary-scan Capabilities According to the JTAG Standard - Extensive On-chip Debug Support - Clock Generator Provides CPU Rates up to 48MHz - Only One External Clock Crystal of 12 MHz Can Generate All the Required System Clocks: - Internal Clock for Standard UART Rates - A 48 MHz and 96 MHz Clock for USB Data Recovery - AVR Processor and System Clock - Full-speed USB Interface (12 Mbits per Second) 2.0 pliant - Two On-chip 16550 UARTs Supporting Baud Rates up to 921 Kbaud - Both UARTs Incorporate individual Transmit and Receive FIFOs of 16 Bytes - UART0 Supports Modem Control Signals - Programmable SPI Interface - On-chip Bootstrap ROM Provides a Variety of Firmware Upgrade Modes - Device Firmware Upgrade Through USB for the internal Program SRAM (No External Non-volatile SPI Memory Required) - Device Firmware Upgrade Through USB for both the Internal Program SRAM and the External SPI Data Flash® or EEPROM - SPI Program Mode from the External Data Flash or EEPROM - DMA Channels Allow Fast Data Transfers between Endpoint Buffers and Internal or External SRAM (DMA Transfer Rate is 12 MHz for All Channels) - 8K x 16 bits (up to 11K x 16 bits), In-System SRAM for Program Code (Program Memory) - On-Chip 8 Kbytes SRAM for Data and Variables ( 2, 4, and 8 Kbytes can be Remapped for Program Storage in the Address Area Above the Program Memory) .. - Two 8-bit Timer/Counters - One 16-bit Timer/Counter - Two External interrupts Through GPIOs - Programmable Watchdog Timer - Low voltage operation: - 1.8V for the Core - 1.8V or 3.3V for the Periphery - 3.3V for the USB - Low cost 64-pin TQFP Package, Suitable for USB-to-UART Bridge Applications High-speed (48 MHz) AVR®- based Bridging Device AT76C712 Summary 5635AS- USB- 12/04 Overview Atmel’s AT76C712 is a low-power USB peripheral that can connect various types of devices to a mon...