AT76C713 Datasheet | Atmel

Features - Advanced RISC Architecture, 130 Powerful Instructions, Most Single-Clock Cycle Execution - Clock Generator Provides CPU Rates up to 48 MHz - Only One External Clock Crystal of 12 MHz Can Generate All the Required System Clocks: - Internal Clock for Standard UART Rates - A 48 MHz and 96 MHz Clock for USB Data Recovery - AVR Processor and System Clock - Full-speed USB Interface (12 Mbits per Second) 2.0 pliant - JTAG (IEEE std. 1149.1 pliant) Interface - Boundary-Scan Capabilities According to the JTAG Standard - Extensive On-Chip Debug Support - Two On-chip 16550 UARTs Supporting Baud Rates up to 921 Kbaud - Both UARTs Incorporate Individual Transmit and Receive FIFOs of 16 Bytes - UART0 Supports Modem Control Signals - Programmable SPI Interface - On-chip Bootstrap ROM Provides a Variety of Firmware Upgrade Modes - Device Firmware Upgrade Through USB for the Internal Program SRAM (No External Non-volatile SPI Memory Required) - Device Firmware Upgrade Through USB for both the Internal Program SRAM and the External SPI Data Flash® or EEPROM - SPI Program Mode from the External Data Flash or EEPROM - External Memory Interface Supporting up to 32 Kbytes of External RAM in Address Multiplexed Mode, 2 Banks of 256 Bytes in Non-multiplexed Mode, FIFO, or with an .. Extra 20 GPIOs - DMA Channels Allow Fast Data Transfers between Endpoint Buffers and Internal or External SRAM (DMA Transfer Rate is 12 MHz for All Channels) - 8K x 16 bits (up to 11K x 16 Bits), In-System SRAM for Program Code (Program Memory) - On-chip 8 Kbytes SRAM for Data and Variables (2, 4, or 6 Kbytes can be Remapped for Program Storage in the Address Area Above the Program Memory - Two 8-bit Timer/Counters - One 16-bit Timer/Counter - Four External Interrupts Through GPIOs - Programmable Watchdog Timer - Low Voltage Operation: - 1.8V for the Core - 1.8V or 3.3V for the Periphery - 3.3V for the USB - 100-pin TQFP Package - Applications - Programmable USB-to-Serial Bridge for RS-2332 Devices...