Datasheet4U Logo Datasheet4U.com

AT90USB128X - USB DFU Bootloader

Description

The 8bits mega AVR with USB interface devices are factory configured with a USB bootloader located in the on-chip flash boot section of the controller.

Features

  • USB Protocol.
  • Based on the USB DFU class.
  • Autobaud (8/16 MHz crystal).
  • In-System Programming.
  • Read/Write Flash and EEPROM on-chip memories.
  • Read Device ID.
  • Full chip Erase.
  • Start.

📥 Download Datasheet

📁 Similar Datasheet

  • AT90-0001 - Digital Attenuator/ 31.0 dB/ 5-Bit/ TTL Driver/ DC-6.0 GHz (Tyco Electronics)
  • AT90-0106 - Digital Attenuator/ 50 dB/ 6-Bit/ TTL Driver/ DC-2.4 GHz (Tyco Electronics)
  • AT90-0107 - Digital Attenuator/ 31.5 dB/ 6-Bit/ TTL Driver/ DC-4.0 GHz (Tyco Electronics)
  • AT90-0233 - Digital Attenuator/ 30 dB/ 4-Bit/ TTL Driver/ DC - 2.5 GHz (Tyco Electronics)
  • AT90-0263 - Digital Attenuator/ 31 dB/ 5-Bit/ TTL Driver/ DC-4.0 GHz (Tyco Electronics)
  • AT90-0283 - Digital Attenuator/ 15.5 dB/ 5-Bit/ TTL Driver/ DC-3.5 GHz (Tyco Electronics)
  • AT90-0413 - Digital Attenuator/ 15 dB/ 4-Bit/ TTL Driver/ DC - 4.0 GHz (Tyco Electronics)
  • AT90-1106 - Digital Attenuator/ 50 dB/ 6-Bit/ TTL Driver/ DC-2.4 GHz (Tyco Electronics)
  • AT90-1107 - Digital Attenuator/ 31.5 dB/ 6-Bit/ TTL Driver/ DC-4.0 GHz (Tyco Electronics)
  • AT90-1233 - Digital Attenuator/ 30 dB/ 4-Bit/ TTL Driver/ DC - 2.5 GHz (Tyco Electronics)
Other Datasheets by ATMEL

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com Features • USB Protocol – Based on the USB DFU class – Autobaud (8/16 MHz crystal) • In-System Programming – Read/Write Flash and EEPROM on-chip memories – Read Device ID – Full chip Erase – Start application command • In-Application Programming – Software Entry-points for on-chip flash drivers 1. Description The 8bits mega AVR with USB interface devices are factory configured with a USB bootloader located in the on-chip flash boot section of the controller. This USB bootloader allows to perform In-System Programming from an USB host controller without removing the part from the system or without a pre-programmed application, and without any external programming interface.
Published: |