AM29F016 Datasheet | Advanced Micro Devices

FINAL 16-Megabit (2,097,152 x 8-Bit) CMOS 5.0 Volt-only, Sector Erase Flash Memory DISTINCTIVE CHARACTERISTICS s 5.0 Volt ± 10% for read and write operations - Minimizes system level power requirements s patible with JEDEC-standards - Pinout and software patible with single-power supply Flash - Superior inadvertent write protection s 48-pin TSOP s 44-pin SO s Minimum 100,000 write/erase cycles guaranteed s High performance - 70 ns maximum access time s Sector erase architecture - Uniform sectors of 64 Kbytes each - Any bination of sectors can be erased. Also supports full chip erase s Group sector protection - Hardware method that disables any bination of sector groups from write or erase operations (a sector group consists of 4 adjacent sectors of 64 Kbytes each) s Embedded Erase Algorithms - Automatically pre-programs and erases the chip or any sector s Embedded Program Algorithms - Automatically programs and verifies data at specified address s Data Polling and Toggle Bit feature for detection of program or erase cycle pletion s Ready/Busy output (RY/BY) - Hardware method for detection of program or erase cycle pletion s Erase Suspend/Resume - Supports reading or programming data to a sector not being erased s Low power consumption - 25 m A typical active read current - 30 m A typical program/erase current s Enhanced power management for standby mode - <1 µA typical standby current - Standard access time from standby mode s Hardware RESET pin - Resets internal state machine to the read mode GENERAL DESCRIPTION The Am29F016 is a 16 Mbit, 5.0 Volt-only Flash memory organized as 2 Megabytes of 8 bits each. The 2 Mbytes of data is divided into 32 sectors of 64 Kbytes for flexible erase capability. The 8 bits of data appear on DQ0- DQ7. The Am29F016 is offered in 48-pin TSOP and 44-pin SO packages. This device is designed to be programmed in-system with the standard system 5.0 Volt VCC supply. 12.0 Volt V PP is not required for program or...