Datasheet4U Logo Datasheet4U.com

ADXL05 - Single Chip Accelerometer

General Description

The ADXL05 is a complete acceleration measurement system on a single monolithic IC.

The ADXL05 will measure accelerations with full-scale ranges of ± 5 g to ± 1 g or less.

Key Features

  • a TTL compatible self-test function that can electrostatically deflect the sensor beam at any time to verify that the sensor and its electronics are functioning correctly. The ADXL05 is available in a hermetic 10-pin TO-100 metal can, specified over the 0°C to +70°C commercial, and.
  • 40°C to +85°C industrial temperature ranges. Contact factory for availability of automotive grade devices.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ADX111 16-Bit ADC AnalogySemi
ADX111Q 16-Bit ADC AnalogySemi
ADX112 High-Precision SD ADC AnalogySemi
ADX112Q High-Precision SD ADC AnalogySemi
ADX320Q Simultaneous Sampling Analog-to-Digital Converter AnalogySemi

Other Datasheets by Analog Devices

Part Number Description
ADXL001 Wide Bandwidth Accelerometer
ADXL1001 High Frequency MEMS Accelerometers
ADXL1002 High Frequency MEMS Accelerometers
ADXL1003 MEMS Accelerometer
ADXL1004 MEMS Accelerometer

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
a ؎1 g to ؎5 g Single Chip Accelerometer with Signal Conditioning ADXL05* floor is 500 µg/√Hz, (12× less than the ADXL50), allowing signals below 5 milli-g to be resolved. The ADXL05 is a force balanced capacitive accelerometer with the capability to measure both ac accelerations (typical of vibration) or dc accelerations (such as inertial force or gravity). Three external capacitors and a +5 volt regulated power supply are all that is required to measure accelerations up to ± 5 g. Three resistors are used to configure the output buffer amplifier to set scale factors from 200 mV/g to 1 V/g. External capacitors may be added to the resistor network to provide 1 or 2 poles of filtering.