Datasheet4U Logo Datasheet4U.com

MAX22205 - 7.6A High Current Single H-Bridge

General Description

The MAX22205 integrates a high current 65V, 7.6AMAX H-Bridge to drive one Brushed DC motor or one half Stepper motor.

The H-Bridge FETs feature very low impedance, resulting in high driving efficiency and low heat.

The typical total RON (high-side + low-side) is 0.15Ω.

Key Features

  • an accurate optional Current Drive Regulation (CDR), which can be used to limit the start up current of a Brushed DC motor or control the phase current for stepper operation. The bridge output current is sensed by a non-dissipative Integrated Current Sensing (ICS) and it is then compared with the desired threshold current. As soon as the bridge current exceeds the threshold (ITRIP), the device enforces the decay for a fixed OFFtime (tOFF). The non-dissipative ICS eliminates the bulky external po.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX222 5-V DUAL RS-232 LINE DRIVER/RECEIVER Texas Instruments
MAX222 +5V-Powered / Multichannel RS-232 Drivers/Receivers Maxim
MAX220 +5V-Powered Multichannel RS-232 Drivers/Receivers MAXIM
MAX2202 RMS Power Detector Maxim Integrated
MAX2203 RMS Power Detector Maxim Integrated Products

Other Datasheets by Analog Devices

Part Number Description
MAX22212 7.6A High Current Single H-Bridge
MAX22213 3.8A Quad Half H-Bridge Drivers
MAX22216 Quad Smart Serial-Controlled Solenoid and Motor Driver
MAX22217 Quad Smart Serial-Controlled Solenoid and Motor Driver
MAX22163 6-Channel Digital Isolators

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MAX22205 65V, 7.6A High Current Single H-Bridge with Integrated Current-Sense General Description The MAX22205 integrates a high current 65V, 7.6AMAX H-Bridge to drive one Brushed DC motor or one half Stepper motor. The H-Bridge FETs feature very low impedance, resulting in high driving efficiency and low heat. The typical total RON (high-side + low-side) is 0.15Ω. The HBridge can be PWM controlled by two logic inputs (DINA, DINB). A third Enable (EN) logic input can be used to configure the outputs to high impedance for coasting the motor. The MAX22205 features an accurate optional Current Drive Regulation (CDR), which can be used to limit the start up current of a Brushed DC motor or control the phase current for stepper operation.