Datasheet4U Logo Datasheet4U.com

AH1801 - ULTRA-SENSITIVE HALL EFFECT SWITCH

General Description

AH1801 is a Micropower, Ultra-sensitive Hall Effect Switch, which is with two Hall effect plates and a output driver, mainly designed for battery

operation, hand-held equipment (such as Cellular and Cordless Phone, PDA).

The total operation power is down to 24µW in the 3V supply.

Key Features

  • Micropower Operation.
  • Operation with North or South Pole.
  • 2.5V to 5.5V Battery Operation.
  • Inverted Output-on without Magnet Present.
  • Chopper Stabilized.
  • Superior Temperature Stability.
  • Extremely Low Switch-Point Drift.
  • Insensitive to Physical Stress.
  • Good RF Noise Immunity.
  • -40C to +85C Operating Temperature.
  • Low Profile 3 Pin SC59 (Commonly Known as SOT23 in Asia) and DFN2020-3, DFN2020-6 Packages.
  • ESD (HBM) ＞ 5KV for DFN2020-3 and.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AH180 MICROPOWER OMNIPOLAR HALL-EFFECT SENSOR SWITCH Diodes Incorporated
AH182 (AH182 / AH183) LOW POWER HALL EFFECT SWITCH Diodes Incorporated
AH182 (AH182 / AH183) Low power Hall Effect Switch ANACHIP
AH183 (AH182 / AH183) LOW POWER HALL EFFECT SWITCH Diodes Incorporated
AH183 (AH182 / AH183) Low power Hall Effect Switch ANACHIP

Other Datasheets by Diodes Incorporated

Part Number Description
AH1802 ULTRA-SENSITIVE OMNIPOLAR HALL-EFFECT SENSOR SWITCH
AH1803 ULTRA-SENSITIVE HALL EFFECT SWITCH
AH1804 MICROPOWER OMNIPOLAR HALL EFFECT SENSORSWITCH
AH1806 HIGH SENSIVITY MICROPOWER OMNIPOLAR HALL-EFFECT SWITCH
AH1807 MEDIUM SENSITIVITY MICROPOWER OMNIPLOAR HALL-EFFECT SWITCH

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
NOT RECOMMENDED FOR NEW DESIGN USE AH1808 AH1801 MICROPOWER, ULTRA-SENSITIVE HALL EFFECT SWITCH Description AH1801 is a Micropower, Ultra-sensitive Hall Effect Switch, which is with two Hall effect plates and a output driver, mainly designed for battery–operation, hand-held equipment (such as Cellular and Cordless Phone, PDA). The total operation power is down to 24µW in the 3V supply. Either north or south pole of sufficient strength will turn the output off. The output will be turned on under no magnetic field. While the magnetic flux density (B) is larger than operate point (Bop), the output will be turned off, the output is held until B is lower than release point (Brp), then turned on. Pin Assignments ( Top View ) GND 3. 2. Output 1. VDD ( Top View ) 3.