ELM Electronics ELM311
The ELM311 is an interface circuit for use between high speed logic and four phase stepper motor driver circuits. This circuit supports only one mode of operation, the full-step, or single phase wave mode, as it is sometimes called. This mode provides sequential single phase output signals for driving a variety of motors.| Part No. | ELM311 |
|---|---|
| Datasheet | ELM311 Download |
| Manufacturer |  ELM Electronics |
| Description | Stepper Motor Controller |
| Buy | Stock & Price |
DESCRIPTION
All of the logic required to provide stepping in two directions is contained in this one 8 pin package. For dual mode operation, the ELM310 should be considered. The ELM311 can be controlled by a wide variety of circuits, due to its fully static operation. In addition to using high speed microprocessor control, suitably debounced mechanical switches or continuously running oscillator circuits could also be used.FEATURES
● Low power CMOS design - typically 1mA at 5V● Wide supply range - 3.0 to 5.5 volt operation
● Two inputs control Full step motion
● No external timing components
● Completely static operation - will maintain a step position indefinitely
● High current drive outputs - up to 25 mA
● Very high speed - up to 25000 steps per second Connection Diagram PDIP and SOIC (top view)
APPLICATIONS
● Stepper motor drive logic● Process sequencing
● Sequential left/right LED driver VDD 1 A2 Dir 3 Step 4 8 VSS 7B 6C 5D Block Diagram 20msec Startup Timer Inhibit Dir 3 Step...
