IP175CH Datasheet | IC Plus

Features General Description IP175A PCB patible (pins patible) IP175C/IP175CH integrates a 6-port switch Built in 6 MAC and 5 PHY controller, SSRAM, and 5 10/100 Ethernet Each port can be configured to be 10Base-T, transceivers. Each of the transceivers plies with 100Base-TX the IEEE802.3, IEEE802.3u, and IEEE802.3x 2k MAC address specifications. The DSP approach is utilized for 384k bits packet buffer memory designing transceivers with 0.18um technology; they Support auto-polarity for 10Mbps have high noise immunity and robust performance. Filter/ forward reserved address option Broadcast storm protection IP175C/IP175CH operates in store and forward Auto MDI-MDIX mode. It supports flow control, auto MDI/MDI-X, Support three MII/RMII ports Co S, port base VLAN, bandwidth control, Diff Serv, Support SMI with MDC up to 12.5 Mhz SMART MAC and LED functions, etc. Each port can Support tagging & un-tagging be configured to auto-negotiation or forced Support Port base VLAN & tag VLAN 10M/100M, full/half duplexmode. Using an Support Co S EEPROM or pull up/down resistors on specified pins Support port security option can configure the desired options. Support SMART MAC function Support spanning tree protocol Besides a 5-port switch application, Max packet length 1552/ 1536 bytes IP175C/IP175CH supports three MII/RMII ports for Support 8-level bandwidth control router application, which supports 4 LAN ports, one Support Link quality LED for 100Mbps WAN port and one HOME/PNA or Access point. The Support direct, serial and dual color mode LED external MAC can monitor or configure Support one fiber port with far end fault function IP175C/IP175CH by accessing MII registers through for IP175CH only SMI0. Built in linear regulator control circuit Low power consumption MII/RMII port also can be configured to be MAC 0.18um, 128-pin PQFP mode. It is used to interface an external PHY to Support Lead Free package (Please refer to the work as a 5+1 switch. Through SMI1 Order Information)...