IMP522 Datasheet | IMP Inc

Features N Drive two EL lamps independently N Digital LMPSEL pin - Activate either or both EL output drivers N 220VP-P typical AC output voltage drives 30n F EL lamps N Wide operating voltage range: 2V to 6.5V N Low current consumption: 2m A maximum N Disable mode extends battery life - Disable current 2µA maximum N pact 10-pin Micro SO package N High-voltage, low-cost CMOS process Dual EL Lamp Driver The IMP522 is a dual-output, high-voltage electroluminescent (EL) lamp driver. Either or both EL lamp driver outputs can be turned ON with the LMPSEL select pin. One EL lamp is connected between VA and VAB and the other is connected between VB and VAB. VAB is a mon pin for both lamps. With an input supply voltage between 2.0V and 6.5V, the typical regulated lamp drive voltage is 220V peak-to-peak. The device uses a single inductor and a minimum number of passive ponents: a storage capacitor, a fast recovery diode and two resistors to set the PWM and EL drive frequencies. These can be independently set to optimize brightness and minimize power consumption. RSW is connected between the RSW-OSC pin and the supply pin VDD to set the frequency for the internal 4.0Ω switching MOSFET. The switch duty cycle is 88%. The EL lamp driver frequency is set by REL connected between the REL-OSC pin and the VDD pin. Designed to minimize battery current drain, the IMP522 draws 2m A maximum. A power-saving shutdown mode reduces current to 2µA maximum. The IMP522 is available in a pact 10-pin Micro SO package and in die form. Applications N N N N N N Cellular phones PDAs/Handheld puters Toys/Consumer electronics Safety Illumination LCD modules Remote controls LX (4) Block Diagram (2) RSW-OSC VREF (1) VDD Three-Level Detector (9) LMPSEL Select A Lamp Select B Lamp VDD Lamp Drive Oscillator (10) REL-OSC (6) GND © 2001 IMP, Inc. 408-432-9100/.impweb. - VA (8) VAB (7) Dual Bridge Driver VB (5) 522_01.eps Switch Oscillator Regulation Control + CS (3) Pin Configuration Micr...