Datasheet4U Logo Datasheet4U.com

M670 - VOLTAGE CONTROLLED SAW OSCILLATOR

General Description

The M670 is a VCSO (Voltage Controlled SAW Oscillator) frequency source for low-jitter clock generation.

Its integrated SAW (surface acoustic wave) delay line provides low phase jitter.

The M670 is available in a range of center frequencies.

Key Features

  • VCSO center frequencies from 155 to 700 MHz (Specify center frequency at time of order).
  • Low phase jitter 0.19ps rms typical (50kHz-80MHz).
  • Low phase noise -70dBc/Hz @ 1kHz offset.
  • Differential 3.3V LVPECL output.
  • Single 3.3V power supply.
  • Very small 5 x 7mm SMT (surface mount) package Figure 1: Pin Assignment Sample of Available Output Frequencies VCSO Center Frequency1 (MHz) 622.0800 625.0000 644.5313 669.3265.

📥 Download Datasheet

Datasheet Details

Part number M670
Manufacturer Integrated Circuit Systems
File Size 386.25 KB
Description VOLTAGE CONTROLLED SAW OSCILLATOR
Datasheet download datasheet M670 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
M67025E Tolerant High Speed 8 Kb x 16 Dual Port RAM ATMEL Corporation
M67 SIMPLE MELODY GENERATOR Micro Electronics
M67 DOUBLE-BALANCED MIXER Tyco Electronics
M67204F (M6720xxF) Rad Tolerant High Speed 16Kx9 Parallel Fifo ATMEL Corporation
M67204H Rad Tolerant High Speed 4Kx9 CMOS Parallel Fifo ATMEL Corporation

Other Datasheets by Integrated Circuit Systems

Part Number Description
M675 VOLTAGE CONTROLLED SAW OSCILLATOR

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Integrated Circuit Systems, Inc. www.DataSheet4U.com Product Data Sheet M670 nFOUT VOLTAGE CONTROLLED SAW OSCILLATOR PIN ASSIGNMENT (5 x 7mm SMT) FOUT GND VCC GENERAL DESCRIPTION The M670 is a VCSO (Voltage Controlled SAW Oscillator) frequency source for low-jitter clock generation. Its integrated SAW (surface acoustic wave) delay line provides low phase jitter. The M670 is available in a range of center frequencies. Minimum pull-range is ±50 ppm (wider pull-range available). The M670 is well suited for phase-locked loop implementations, clock and data recovery circuits, and other timing applications for the telecom and optical fiber networking markets (e.g., OC-48, OC-192).