Datasheet4U Logo Datasheet4U.com

ACTS138MS - Radiation Hardened TTL Input/ 3-to-8 Line Decoder/Demultiplexer

General Description

The Radiation Hardened ACTS138MS is an Inverting 3-to-8 Line Decoder/Demultiplexer with three TTL level binary select inputs (A0, A1 and A2).

If the device is enabled, these inputs determine which one of the eight normally high outputs will go low.

Key Features

  • QML Qualified Per MIL-PRF-38535 Requirements.
  • 1.25Micron Radiation Hardened SOS CMOS.
  • Radiation Environment - Latch-up Free Under any Conditions - Total Dose.
  • . . 3 x 105 RAD(Si) - SEU Immunity.
  • . 100MeV/(mg/cm2).
  • Input Logic Levels.
  • VIL = 0.8V, VIH = (Vcc/2).
  • Output Current.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ACTS74MS Radiation Hardened Dual-D Flip-Flop Intersil
ACT-D1M96S ACT-D1M96S High Speed 96 MegaBit 3.3V Synchronous DRAM Multichip Module Aeroflex Circuit Technology
ACT-E128K32 High Speed 4 Megabit EEPROM Multichip Module Aeroflex
ACT-F128K32 High Speed 4 Megabit FLASH Multichip Module Aeroflex
ACT-F128K8 High Speed 1 Megabit Monolithic FLASH Aeroflex

Other Datasheets by Intersil (now Renesas)

Part Number Description
ACTS10MS Radiation Hardened Triple Three-Input NAND Gate
ACTS112MS Radiation Hardened Dual J-K Flip-Flop
ACTS125MS Radiation Hardened Quad Buffer/ Three-State
ACTS161MS Radiation Hardened 4-Bit Synchronous Counter
ACTS00MS Radiation Hardened Quad 2-Input NAND Gate

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
ACTS138MS December 1997 Radiation Hardened TTL Input, 3-to-8 Line Decoder/Demultiplexer Description The Radiation Hardened ACTS138MS is an Inverting 3-to-8 Line Decoder/Demultiplexer with three TTL level binary select inputs (A0, A1 and A2). If the device is enabled, these inputs determine which one of the eight normally high outputs will go low. Two active low and one active high enable inputs (E1, E2 and E3) are provided to make cascaded decoder designs easier to implement. The ACTS138MS is fabricated on a CMOS Silicon on Sapphire (SOS) process, which provides an immunity to Single Event Latch-up and the capability of highly reliable performance in any radiation environment. These devices offer significant power reduction and faster performance when compared to ALSTTL types.