Datasheet4U Logo Datasheet4U.com

MP5036A - 0.4A to 5A Current Limit Switch

Description

The MP5036A is a protection device designed to protect circuitry on the output from transients on the input, while simultaneously protecting the input from undesired shorts and transients from the output.

The DV/DT pin controls the slew rate at the output.

Features

  • Wide 2.9V to 5.5V Continuous Operating Input Range.
  • 26V Absolute Maximum Transient Input Voltage.
  • Fixed 5.75V Over-Voltage Clamp Threshold.
  • Fast Output OVP Response.
  • Integrated 43mΩ Power FET.
  • Adjustable Current Limit or Fixed Current Limit when Floating ILIMIT Pin.
  • Soft-Start Time Programmable through DV/DT Pin.
  • Fast Response for Hard Short Protection.
  • OCP Hiccup Protection.
  • Thermal Shutdown and Auto-Retry.
  • Available in a TSOT23-6 Package.

📥 Download Datasheet

Datasheet preview – MP5036A

Datasheet Details

Part number MP5036A
Manufacturer MPS
File Size 913.38 KB
Description 0.4A to 5A Current Limit Switch
Datasheet download datasheet MP5036A Datasheet
Additional preview pages of the MP5036A datasheet.

📁 Similar Datasheet

  • MP503 - Air-Quality Gas Sensor (Winsen)
  • MP503 - PRESS-FIT MOTOLOLA DIODES (Shunye)
  • MP5005 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5005 - PRESS-FIT MOTOLOLA DIODES (Shunye)
  • MP5005W - Single Phase Bridge Rectifier (MCC)
  • MP5006 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5007 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5008 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5009 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP500B - Low Cost Quartz Crystal (CTS)
Other Datasheets by MPS

Full PDF Text Transcription

Click to expand full text
MP5036A 5V, 0.4A to 5A Current Limit Switch with 5.75V Over-Voltage Clamp DESCRIPTION The MP5036A is a protection device designed to protect circuitry on the output from transients on the input, while simultaneously protecting the input from undesired shorts and transients from the output. The DV/DT pin controls the slew rate at the output. The slew rate limits the inrush current during start-up. The maximum load at the output is currentlimited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. There is a fixed, 2.5A current limit when floating the ILIMIT pin. The output voltage is limited by the output’s over-voltage protection (OVP) function. The device is available in a TSOT23-6 package. FEATURES  Wide 2.9V to 5.
Published: |