Datasheet4U Logo Datasheet4U.com

MAX9963 - (MAX9963 / MAX9964) ATE Driver/Comparator

General Description

The MAX9963/MAX9964 four-channel, low-power, highspeed pin electronics driver and comparator ICs include, for each channel, a three-level pin driver, a dual comparator, and variable clamps.

Key Features

  • Small Footprint.
  • Four Channels in 0.4in2 Low Power Dissipation: 825mW/Channel (typ) High Speed: 500Mbps at 3VP-P Low Timing Dispersion Wide -1.5V to +6.5V Operating Range Active Termination (3rd-Level Drive) Low-Leakage Mode: 15nA (max) Integrated Clamps Interface Easily with Most Logic Families Digitally Programmable Slew Rate MAX9963/MAX9964.
  • Internal Logic Termination Resistors.
  • Low Gain and Offset Error Ordering Information PART MAX9963ADCCQ.
  • MAX9963AKCCQ.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX9910 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9911 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9912 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9913 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9914 (MAX9914 - MAX9917) Rail-to-Rail I/O Op Amps Maxim Integrated Products

Other Datasheets by Maxim Integrated (now Analog Devices)

Part Number Description
MAX996 High-Speed / Micropower / Low-Voltage / SOT23 / Rail-to-Rail I/O Comparators
MAX9960 Dual-Flash-Pin Electronics/Supervoltage Switch Matrix
MAX9964 (MAX9963 / MAX9964) ATE Driver/Comparator
MAX9967 ATE Driver/Comparator
MAX9969 ATE Driver/Comparator

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
19-2977; Rev 1; 1/04 Quad, Low-Power, 500Mbps ATE Driver/Comparator General Description The MAX9963/MAX9964 four-channel, low-power, highspeed pin electronics driver and comparator ICs include, for each channel, a three-level pin driver, a dual comparator, and variable clamps. The driver features a wide voltage range and high-speed operation, includes high-Z and active-termination (3rd-level drive) modes, and is highly linear even at low-voltage swings. The dual comparator provides low dispersion (timing variation) over a wide variety of input conditions. The clamps provide damping of high-speed DUT waveforms when the device is configured as a high-impedance receiver. High-speed, differential control inputs compatible with ECL, LVPECL, LVDS, and GTL levels are provided for each channel.