Datasheet4U Logo Datasheet4U.com

MAX9967 - ATE Driver/Comparator

General Description

The MAX9967 dual, low-power, high-speed, pin electronics driver/comparator/load (DCL) IC includes, for each channel, a three-level pin driver, a dual comparator, variable clamps, and an active load.

Key Features

  • a wide voltage range and high-speed operation, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low-voltage swings. The dual comparator provides low dispersion (timing variation) over a wide variety of input conditions. The clamps provide damping of high-speed device-undertest (DUT) waveforms when the device is configured as a high-impedance receiver. The programmable load supplies up to 35mA of source and sink current. The load facilitates con.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX9910 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9911 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9912 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9913 (MAX9910 - MAX9913) Rail-to-Rail I/O Op Amps Maxim Integrated Products
MAX9914 (MAX9914 - MAX9917) Rail-to-Rail I/O Op Amps Maxim Integrated Products

Other Datasheets by Maxim Integrated (now Analog Devices)

Part Number Description
MAX996 High-Speed / Micropower / Low-Voltage / SOT23 / Rail-to-Rail I/O Comparators
MAX9960 Dual-Flash-Pin Electronics/Supervoltage Switch Matrix
MAX9963 (MAX9963 / MAX9964) ATE Driver/Comparator
MAX9964 (MAX9963 / MAX9964) ATE Driver/Comparator
MAX9969 ATE Driver/Comparator

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
19-3195; Rev 1; 2/05 Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load General Description The MAX9967 dual, low-power, high-speed, pin electronics driver/comparator/load (DCL) IC includes, for each channel, a three-level pin driver, a dual comparator, variable clamps, and an active load. The driver features a wide voltage range and high-speed operation, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low-voltage swings. The dual comparator provides low dispersion (timing variation) over a wide variety of input conditions. The clamps provide damping of high-speed device-undertest (DUT) waveforms when the device is configured as a high-impedance receiver. The programmable load supplies up to 35mA of source and sink current.