Datasheet4U Logo Datasheet4U.com

MAS1178 - IC FOR 10.00 - 20.00 MHz VCXO

General Description

The MAS1178 is an integrated circuit well suited to build VCXO for mobile communication.

The trimming is done by a serial bus and the calibration information is stored in an internal PROM.

Key Features

  • Very small size Minor current draw Wide operating temperature range Phase noise.

📥 Download Datasheet

Datasheet Details

Part number MAS1178
Manufacturer Micro Analog systems
File Size 83.81 KB
Description IC FOR 10.00 - 20.00 MHz VCXO
Datasheet download datasheet MAS1178 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAS110S Fast Turn-off Asymmetric Thyristor/Diode Module Dynex
MAS1008 MAS1008 Tesla
MAS1206 Equipment Designed to Conform EMI Regulations Such As VCCI /CISPR /FCC /VDE /etc DENSEI-LAMBDA
MAS1206-33 Equipment Designed to Conform EMI Regulations Such As VCCI /CISPR /FCC /VDE /etc DENSEI-LAMBDA
MAS1210-33 Equipment Designed to Conform EMI Regulations Such As VCCI /CISPR /FCC /VDE /etc DENSEI-LAMBDA

Other Datasheets by Micro Analog systems

Part Number Description
MAS1175 IC FOR 10.00 - 20.00 MHz VCTCXO
MAS1016 am Receiver
MAS1016B am Receiver
MAS1017 am Receiver
MAS6116 Stereo Digital Volume Control

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com DA1178.006 13 July, 2006 MAS1178 This is preliminary information on a new product under development. Micro Analog Systems Oy reserves the right to make any changes without notice. IC FOR 10.00 – 20.00 MHz VCXO Low Power Wide Supply Voltage Range Square Wave Output Very High Level of Integration • Electrically Trimmable • Very Low Phase Noise • Low Cost • • • • To build a VCXO only one additional component, a crystal is needed. DESCRIPTION The MAS1178 is an integrated circuit well suited to build VCXO for mobile communication. The trimming is done by a serial bus and the calibration information is stored in an internal PROM.