MCP2562 Datasheet | Microchip Technology

Features : Description : - Supports 1 Mb/s Operation - Implements ISO-11898-2 and ISO-11898-5  Standard Physical Layer Requirements - Very Low Standby Current (5 µA, typical) - VIO Supply Pin to Interface Directly to  CAN Controllers and Microcontrollers with  1.8V to 5.5V I/O - SPLIT Output Pin to Stabilize mon Mode in Biased Split Termination Schemes - CAN Bus Pins are Disconnected when Device is Unpowered: - An Unpowered Node or Brown-Out Event will Not Load the CAN Bus - Detection of Ground Fault: - Permanent Dominant Detection on TXD - Permanent Dominant Detection on Bus - Power-on Reset and Voltage Brown-Out Protection on VDD Pin - Protection Against Damage Due to Short-Circuit Conditions (Positive or Negative Battery Voltage) - Protection Against High-Voltage Transients in Automotive Environments - Automatic Thermal Shutdown Protection - Suitable for 12V and 24V Systems - Meets or exceeds stringent automotive design requirements including “Hardware Requirements for LIN, CAN and Flex Ray Interfaces in Automotive Applications”, Version 1.3, May 2012 - High-Noise Immunity Due to Differential Bus Implementation - High Electrostatic Discharge (ESD) Protection on CANH and CANL, meeting the IEC61000-4-2 up to ±14 k V - Available in PDIP-8L, SOIC-8L and 3x3 DFN-8L - Temperature ranges: - Extended (E): -40°C to +125°C - High (H): -40°C to +150°C The MCP2561/2 is a Microchip Technology Inc. second generation high-speed CAN transceiver. It serves as an interface between a CAN protocol controller and the physical two-wire CAN bus. The device meets the automotive requirements for high-speed (up to 1 Mb/s), low quiescent current, electromagnetic patibility (EMC) and electrostatic discharge (ESD). Package Types MCP2561 PDIP, SOIC TXD 1 VSS 2 VDD 3 RXD 4 8 STBY 7 CANH 6 CANL 5 SPLIT MCP2562 PDIP, SOIC TXD 1 VSS 2 VDD 3 RXD 4 8 STBY 7 CANH 6 CANL 5 VIO MCP2561 3x3 DFN- TXD...