P82C150AFT Datasheet | NXP Semiconductors

FEATURES GENERAL DESCRIPTION ORDERING INFORMATION BLOCK DIAGRAM FUNCTIONAL DIAGRAM PINNING INFORMATION Pinning Pin description FUNCTIONAL DESCRIPTION I/O functions I/O registers CAN functions Initialization P82C150 operation after RESET or change of bus mode LIMITING VALUES DC CHARACTERISTICS AC CHARACTERISTICS APPLICATION INFORMATION Maximum bus length Start up sequence External oscillator mode Using digital I/O port functions Using DPM Using ADC Using analog input port functions CAN-bus system applications PACKAGE OUTLINE SOLDERING Introduction Reflow soldering Wave soldering Repairing soldered joints DEFINITIONS LIFE SUPPORT APPLICATIONS P82C150 1996 Jun 19 Philips Semiconductors Preliminary specification CAN Serial Linked I/O device (SLIO) with digital and analog port functions 1 FEATURES 2 GENERAL DESCRIPTION P82C150 - Single-chip I/O device with CAN protocol controller - Meets CAN protocol specification version 2.0 A and B (passive) with restricted bit timing - Fully integrated clock oscillator (no crystal required) - 16 configurable digital or analog I/O port pins - Each of the port pins individually configurable via CAN-bus: port direction, port mode and event capture facilities for inputs (event driven or polling) - Up to sixteen digital inputs; automatic transmission of a CAN message on a change on inputs individually selectable - Up to sixteen 3-state outputs - Up to two quasi-analog outputs with 10-bit accuracy - 10-bit analog-to-digital converter with up to six multiplexed analog input channels (for accuracy see Section 11.6) - Two general purpose parators - Bit rate from 20 kbit/s up to 125 kbit/s using internal oscillator - Automatic bit rate detection and calibration - Up to sixteen P82C150 nodes for one CAN-bus system - Four identifier bits programmable - SLIO functions controlled by a single intelligent node (‘host’) - Sleep-mode with wake-up via CAN-bus - Differential CAN-bus input parator and CAN-bus output driver - Supply voltage: 5 V...