SMQ Datasheet | Nippon

.. LARGE CAPACITANCE ALUMINUM ELECTROLYTIC CAPACITORS Downsized snap-ins, 85C @Downsized from current downsized snap-ins SMH series @Endurance with ripple current : 2,000 hours at 85C @Non solvent-proof type @Ro HS pliant Downsized SMH ?SPECIFICATIONS Items Category Temperature Range Rated Voltage Range Capacitance Tolerance Leakage Current Dissipation Factor (tane) Low Temperature Characteristics (Max. Impedance Ratio) Endurance -25 to +85C 160 to 450Vdc P20% (M) I[3 CV Where, I : Max. leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (V) Rated voltage (Vdc) 160 to 250V 315 to 400V 420 & 450V tan E (Max.) 0.20 0.15 0.15 Rated voltage (Vdc) 160 to 250V 315 to 400V 420 & 450V Z(-25C)/Z(+20C) 8 8 4 (at 20C, 120Hz) (at 20C after 5 minutes) (at 20C, 120Hz) Characteristics Shelf Life (at 120Hz) The following specifications shall be satisfied when the capacitors are restored to 20C after subjected to DC voltage with the rated ripple current is applied for 2,000 hours at 85C. Capacitance change [P20% of the initial value D.F. (tan E) [200% of the initial specified value Leakage current [The initial specified value The following specifications shall be satisfied when the capacitors are restored to 20C after exposing them for 1,000 hours at 85C without voltage applied. Capacitance change [P15% of the initial value D.F. (tan E) [150% of the initial specified value Leakage current [The initial specified value ?DIMENSIONS [mm] @Terminal Code : VS (F22 to F35) : Standard Sleeve (PET : Black) FD+1max. Negative mark PC board pin-out FD+1max. @Terminal Code : LI (F35) Sleeve (PET : Black) Negative mark 4.2P0.5 PC board pin-out 2-1.2B6 2-F2 LP2 4.0P0.5 5P0.5 LP2 4.5P1 14.2P1 Vent Vent No plastic disk is the standard design. ?PART NUMBERING SYSTEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 E S MQ A A A V S N A A A M A A A S Supplement code Size code Capacitance tolerance code Capacitance code (ex. 82MF:820, 3,300MF:332) Dummy terminal code...