NCP374 - Overvoltage and over-current protection

onsemi

General Description

Pin 1, 2 Pin Name VBUS Type POWER Description VBUS voltage pins: must be hardwired together on the PCB.

These pins are connected to the VBUS connector, and are protected against positive and negative overvoltage events.

Key Features

http://onsemi. com.

📥 Download Datasheet

NCP374 overvoltage and over-current protection by onsemi - Datasheet Preview

Datasheet Details

Part number	NCP374
Manufacturer	onsemi
File Size	162.79 KB
Description	Overvoltage and over-current protection
Datasheet	NCP374 Datasheet

📁 Similar Datasheet

Part Number	Description	Manufacturer
NCP304	Voltage Detector	ON
NCP305	Voltage Detector	ON
NCP3296	40A Stackable Synchronous Buck Regulator	onsemi
NCP345	Overvoltage Protection	ON
NCP346	Overvoltage Protection	onsemi

Other Datasheets by onsemi

Part Number	Description
NCP370	Positive and Negative Overvoltage Protection
NCP3712ASN	Over Voltage Protected High Side Switch
NCP372	Positive and Negative Overvoltage Protection Controller
NCP373	Over-Voltage and Over-Current protection device
NCP300	Voltage Detector

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text

NCP374 Overvoltage Up to +30 V and Down to -30 V with Load Switch Function NCP374 is an over−voltage and over−current protection device. From IN to VBUS , the part acts as a load switch protection, with programmable current regulation. The current protection is externally adjustable. Additional voltage protection is available, from VBUS to IN. Due to built−IN low RDS(on) NMOS fet, the host system is protected against positive and negative voltage up to +28 V and down to −28 V. The both embedded over−current and over−voltage protection allows sustaining extreme conditions from short circuit on USB connector, or defective WA or USB port. Due to the NCP374 using internal NMOS, the system cost and the PCB area of the application board are minimized.