NCV7685 Datasheet | onsemi

12 Channels 60 m A LED Linear Current Driver I2C Controllable for Automotive Applications The NCV7685 consists of twelve linear programmable constant current sources with mon reference. The part is designed for use in the regulation and control of LED for automotive applications. The NCV7685 allows 128 different duty cycle levels adjustable using pulse width modulation (PWM) independently for each output channel programmable via I2C serial interface. PWM frequency can be chosen in four different configurations up to 1200 Hz. The device can be used with micro- controller applications using the I2C bus or in stand- alone applications where a choice could be done in between two different static configuration settings. The IC also provides 3.3 V voltage reference to the application for loads up to 1 m A. LED brightness level is easily programmed using an external resistor. Each channel has an internal circuitry to detect open- load conditions with an optional auto- recovery mode. If one driver is in open- load condition, all other channels could be turned off according to the programmable bit setting. The device is available in small body size SSOP24- EP package. Features - 12 mon Current Programmable Sources up to 60 m A - Independent PWM Duty Cycle Control for each Channel via PC - mon PWM Duty Cycle Control via I2C - On- Chip 150, 300, 600 and 1200 Hz PWM - Open LED String Diagnostics - Low Dropout Operation for Pre- Regulator Applications - Single Resistor for Current Set Point - Voltage Reference 3.3 V/1 m A - 8 Bits I2C Interface with CRC8 Error Detection - OTP Bank for Stand- Alone Operation (2 Configurations) - Output Enable Pin - Detection and Protection Against Open Load and Under- Voltage - Over Temperature Detection and Protection - Low Emission with Spread Spectrum Oscillator - NCV Prefix for Automotive and Other Applications Requiring Unique Site and Control Change Requirements; AEC- Q100 Qualified and PPAP Capable - SSOP24- EP Packaging Applications -...