EE-SX460-P1 Datasheet | OMRON

Features - - - - - - Snap-in mounting model. Mounts to 0.8- to 1.6-mm-thick panels. High resolution (aperture width of 0.5 mm) With a 5-mm-wide slot. Photo IC output signals directly connect with C-MOS and TTL. Connects to Tyco Electronics AMP’s EI-series connectors. Optical axis 0.5 (Aperture width) Two, R1 Optical axis 15±0.2 I Absolute Maximum Ratings (Ta = 25°C) Item Power supply voltage Output voltage Output current Permissible output dissipation Ambient temperature Operating Storage Symbol VCC VOUT IOUT POUT Topr Tstg Tsol Rated value 10 V 28 V 16 m A 250 m W (see note) - 20°C to 75°C - 40°C to 85°C --- Mounting face Internal Circuit Unless otherwise specified, the tolerances are as shown below. Dimensions 3 mm max. 3 < mm ≤ 6 6 < mm ≤ 10 10 < mm ≤ 18 18 < mm ≤ 30 Tolerance ±0.3 ±0.375 ±0.45 ±0.55 ±0.65 Soldering temperature Note: Refer to the temperature rating chart if the ambient temperature exceeds 25°C. Terminal No. V O G Name Power supply (Vcc) Output (OUT) Ground (GND) I Ordering Information Description Photomicrosensor (transmissive) Model EE-SX460-P1 Remended Mating Connectors: Tyco Electronics AMP 171822-3 (crimp connector) 172142-3 (crimp connector) OMRON EE-1005 (with harness) I Electrical and Optical Characteristics (Ta = 25°C, VCC = 5 V±10%) Item Current consumption Low-level output voltage High-level output voltage Response frequency Symbol ICC VOL VOH f 30 m A max. 0.3 V max. (VCC x 0.9) V min. 3 k Hz min. Value Condition With and without incident IOUT = 16 m A with incident VOUT = VCC without incident, RL = 47 kΩ VOUT = VCC, RL = 47 kΩ (see note) Note: The value of the response frequency is measured by rotating the disk as shown below. Disk 2.1 mm 0.5 mm 0.5 mm t = 0.2 mm .Data Sheet.in Photomicrosensor (Transmissive) EE-SX460-P1 I Engineering Data Output Allowable Dissipation vs. Ambient Temperature Characteristics Output allowable dissipation Pc (m W) Sensing Position Characteristics (Typical) d1 = 0±0.3 mm VCC = 5 V...