EE-SX461-P11 Datasheet | OMRON

Features - - - - - - Snap-in-mounting model. Mounts to 0.8- to 1.6-mm-thick panels. With a 15-mm-wide slot. Photo IC output signals directly connect with C-MOS and TTL. Connects to Tyco Electronics AMP’s EI-series connectors. Ro HS pliant. I Absolute Maximum Ratings (Ta = 25°C) 2 (Aperture width) Two, R1 (15) Optical axis Item Power supply voltage Output voltage Output current Permissible output dissipation Ambient temperature Operating Storage Symbol VCC VOUT IOUT POUT Topr Tstg Tsol 7V Rated value 28 V 16 m A 250 m W (see note) - 20°C to 75°C - 40°C to 85°C --- Internal Circuit Soldering temperature Unless otherwise specified, the tolerances are as shown below. Dimensions 3 mm max. 3 < mm ≤ 6 6 < mm ≤ 10 10 < mm ≤ 18 18 < mm ≤ 30 Tolerance Note: Refer to the temperature rating chart if the ambient temperature exceeds 25°C. Terminal No. V O G Name Power supply (Vcc) Output (OUT) Ground (GND) ±0.3 ±0.375 ±0.45 ±0.55 ±0.65 I Ordering Information Description Photomicrosensor (transmissive) Model EE-SX461-P11 Remended Mating Connectors: Tyco Electronics AMP 171822-3 (crimp connector) 172142-3 (crimp connector) OMRON EE-1005 (with harness) I Electrical and Optical Characteristics (Ta = 25°C, VCC = 5 V±10%) Item Current consumption Low-level output voltage High-level output voltage Response frequency Symbol ICC VOL VOH f 35 m A max. 0.3 V max. (VCC x 0.9) V min. 3 k Hz min. Value Condition With and without incident IOUT = 16 m A with incident VOUT = VCC without incident, RL = 47 kΩ VOUT = VCC, RL = 47 kΩ (see note) Note: The value of the response frequency is measured by rotating the disk as shown below. Disk 2.1 mm 0.5 mm 0.5 mm t = 0.2 mm .Data Sheet.in Photomicrosensor (Transmissive) EE-SX461-P11 I Engineering Data Output Allowable Dissipation vs. Ambient Temperature Characteristics Output allowable dissipation Pc (m W) Sensing Position Characteristics (Typical) d1 = 0±1.1 mm VCC = 5 V Ta = 25°C RL = 47 kΩ Output transistor Center of optical...